aFe Power 90-59999 Installation guide

Brand: aFe Power

Model: 90-59999

Type: Installation guide

Congratulations on your purchase of an aFe Pro Dry S oil-free dry lter. Your new lter uses a

revolutionary synthetic dry media that requires no oil to lter out dirt. Your new aFe Pro Dry S

will provide more airow for increased horsepower, torque, and fuel economy. Pro Dry S lters

are cleanable and reusable. And because they use no oil, cleaning is quick and easy.

You can wash your Pro Dry S lter and return it to 100% of its

original airow. Remove the lter from the intake kit. Run the lter

under running water from the inside out. Turn the lter to remove

all visible and hidden dirt. If your lter is coated with grease or

road grime, it may be necessary to use soap and water to get it

fully clean. You can completely submerge the lter in a mixture of

warm water and mild detergent (use a common household de-

tergent such as dish or liquid laundry soap) if needed. Rinse clean.

Allow the lter to dry completely (our synthetic media dries quickly

and should dry within a few hours in normal conditions). Reinstall

the lter in your vehicle. Do not apply oil to the lter.

NEVER OIL YOUR aFe PRO DRY S FILTER

252 Granite St. Corona, CA 92879

951-493-7100 www.aFepower.com

advanced FLOW engineering

Part #06-00074, Rev B

TM

aFe Power Logo Spec Sheet

You can tap your Pro Dry S lter and return it

to 85% of its original airow. Simply remove

the lter from the intake kit and lightly tap it

on a solid surface. Tap and turn the top and

bottom of the lter until most of the visible dirt

has been released. Reinstall the lter in your

vehicle. Do not apply oil to the lter.

TAP CLEAN 85% CLEAN

You can vacuum your Pro Dry S lter and

return it to 96% of its original airow. Remove

the lter from the intake kit and vacuum

away the dirt using a shop vacuum or regular

house vacuum. Reinstall the lter in your

vehicle. Do not apply oil to the lter.

VACUUM CLEAN 96% CLEAN

You can wash your Pro Dry S lter and return

it to 100% of its original airow. Remove the

lter from the intake kit and simply spray

the lter with .aFe cleaner and let sit for 10

minutes.

WASH CLEAN STEP 1 WASH CLEAN STEP 2 WASH CLEAN STEP 3

Rinse the lter with clean water to remove

the dirt and excess cleaner. Continue rinsing

until the water runs clear.

Allow the lter to dry completely (our

synthetic media dries quickly and should dry

within a few hours in normal conditions).

Reinstall the lter in your vehicle. Do not

apply oil to the lter.

100% CLEAN

1

aFe Power 90-59999 Installation guide

Brand: aFe Power

Model: 90-59999

Type: Installation guide

Download PDF

Related papers

Other documents