Page 1 OF 7
UMBRELLA
Warnings: You must read this before you proceed.
Page 2 OF 7
Part NO. Picture Description QTY
A Base 1PC
B Big Plastic Cone 1PC
C Small Plastic Cone 1PC
D
360°Swivel Mechanism
with FOOT LEVER
1PC
E Umbrella Base Pole 1PC
F Crank 1PC
G
Umbrella Frame &
Canopy
1PC
Page 3 OF 7
Label Picture Description QTY
1 Bolt(M10*20mm) 8PCS
2 Washer 8PCS
3 Screw With Plastic Cap 1PC
4 Allen Key 1PC
Before Beginning Assembly:
Unpack all
the parts
for a clear
overview.
Page 4 OF 7
Step 1
Step 2
Step 3
Step 4
Unpack the package and place all parts on a soft, non marring
surface.Fix the 360°Swivel Mechanism with FOOT LEVER(D) to the
Base(A) with Bolt(1) and Washer(2) by Allen Key(4). Keep the foot lever
angle upward angled.
Twist off the plastic cap from the Base(A), tighten the cap after filling up
the base with water. Drain off the water through the drain hole when
move.
Fix the Umbrella Base Pole(E) to 360°Swivel Mechanism with FOOT
LEVER(D) with Bolt(1)and Washer(2) by Allen Key(4).
Place the Plastic Cone (B+C) onto the Umbrella Base Pole (E).
Page 5 OF 7
Step 5
Step 6
Step 7
Insert the pole of the Umbrella Frame & Canopy (G) onto the Umbrella
Base pole (E). Fix the Screw With Plastic Cap (3) in place to ensure that
the pole is tightly secured to the base.
Squeeze and hold the hand grip, push it upwards along the pole to the
desired position, then, move the umbrella to an upwards position.
Insert the Crank(F) to the hand grip on the Umbrella Frame & Canopy
(G). Then open the umbrella by rotating the Crank(F) clockwise for
opening, counterclockwise, for closing.
Page 6 OF 7
Step 8
Step 9
Step 10
Test Step on the foot lever on the base and turn the umbrella pole
Clockwise or Counterclockwise to the desired direction.
For adjusting the umbrella angle,squeeze the hand grip and move
upwards or downwards along the pole.
The umbrella is fully assembled and ready for use.
Page 7 OF 7
/
