CMA Dishmachines SCULLERY S-AH Quick Installation Guide

Type
Quick Installation Guide

This manual is also suitable for

MODEL AH REAR VIEW
Connect dishmachine to hot water source
recommended 140
temperature (120
minimum temperature required).
2
STEP
Connect the drain pipe from scrap
accumulator to floor or wall drain.
1
STEP
WALL
DRAIN
FLOOR DRAIN
Insert tube stiffener with chemical tubing
into each corresponding chemical
dispensers.
BLUE
RED
WHITE
3
STEP
TUBE
STIFFENER
AUTO START
SWITCH
POWER SWITCH
2" DRAIN
OUTLET
CHEMICAL
TUBING
3/4" WATER
INLET
HARD WIRE
POWER SUPPLY
2
3
3
1
7-1/2"
11"
WARNING: Electrical and plumbing connections
need to be made by a licensed service person
and comply with all Federal, State and Local
Health, Electrical, Plumbing and Safety codes.
1-2018
Models AH, C, B,
CB and Scullery B
Quick Setup
Instructions
PN: 10130.07
MODEL AH FRONT VIEW
POLY PRO
TM
SCRAP
ACCUMULATOR
PRIMER
SWITCHES
5
PERISTALTIC
PUMPS
FILL/START
SWITCH
6
DOOR
HANDLE
7
6
STEP
Press and hold the Fill/Start Switch until the
water level is approximately 1/2" to 3/4" below
the overflow hole in the PVC standpipe.
FILL
5
STEP
Press and hold down the three Primer Toggle
Switches for the chemical pumps until product
is discharging into the machine.
FILL
To start machine close the doors. The machine
will automatically start and run through its cycle.
7
STEP
THERMOMETER
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front to back, side
to side to ensure proper performance.
4
STEP
LEVELING
LEGS
4
1-2018
WARNING: Electrical and plumbing connections
need to be made by a licensed service person
and comply with all Federal, State and Local
Health, Electrical, Plumbing and Safety codes.
Models AH, C, B,
CB and Scullery B
Quick Setup
Instructions
The Spirit of Excellence
an Ali Group Company
PN: 10130.07
  • Page 1 1
  • Page 2 2

CMA Dishmachines SCULLERY S-AH Quick Installation Guide

Type
Quick Installation Guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI