Mounting Dream MD5109-KD User guide

Brand: Mounting Dream

Model: MD5109-KD

Type: User guide

Please read this instruction carefully before installation

.

Anti-tip Strap INSTALLATION INSTRUCTION

(A0)

If you have any questions, please feel free to contact us:

USA E-mail: customerservice@mountingdream.com

Phone call: (626) 604-9048 (USA) Mon - Fri 10am - 6pm (Pacific Time)

EU E-mail: customercare@mountingdream.com

WARNING:

This product contains small items that could be a choking hazard if swallowed. Before

starting assembly, verify all parts are included and undamaged. For parts shortage or damage, please contact

us via customerservice@mountingdream.com (USA) or customercare@mountingdream.com (EU).

NOTE: Not all hardware included will be used.

Installation Tools:

2M2M

Bubble Level

Band Tape

Screwdriver

Part List:

Anti-tip Strap 1pc

Installation Hardware:

- Lag Bolt 1pc

For concrete installations ONLY

CAUTION:

Do not use in drywall or wood

stud.

- Concrete Anchor 1pc

- M4X20 Bolt 2pcs

1

2

Figure 1

Attach one end of the anti-tip strap to table top TV stand by using

bolt with Allen key (Bolt and Allen key are both included in the hardware

package of MD5109). (

Figure 1

)

Figure 2

3

Step 2A Strap attaches to the table See Page 3

Step 2B Strap attaches to the wall See Page 5

Attach the other end of strap to the wooden table by using bolts

with screwdriver. (Figure 2)

Adjust the length of strap,make sure it is tightened firmly and safe

enough. (

Figure 3

)

Figure 3

4

Use a stud finder to make marks at the edges of one stud, and mark

centerline of stud. Then place iron plate along the centerline and use

pencil to mark center hole location on the wall.

Use 1/16" diameter drill bit to drill a hole at marked position to a depth

of 1.4".

Put lag bolt into the drilled hole, and tighten the bolt by using a

screwdriver to mount the plate securely.

(

Figure 4

)

5

drywall with

wood stud

Figure 4

Option 1

：

Wood Stud Installation

Figure 5

Concrete

wall

6

Use 1/4"(6.4mm) diameter drill bit to drill a hole at marked position to a

depth of 1.4".

Put anchor into drilled hole, and tap the anchor flush with the wall

by using a hammer. Then put lag bolt into the anchor, and tighten

bolt by using a screwdriver to mount the wall plate securely.

(

Figure 5

)

Option 2

：

Solid Conrete Wall Installation

Figure 6

7

Adjust the length of strap,make sure it tight and safe. (

Figure 6

)

1
2
3
4
5
6
7
8

Mounting Dream MD5109-KD User guide

Brand: Mounting Dream

Model: MD5109-KD

Type: User guide

Related papers

Other documents