8
Instruction CF-RU Repeater Unit
VI.UH.N1.52
Produced by Danfoss Floor Heating Hydronics 08.2008
3. Placing and Mounting
The Repeater Unit has been assigned
When the Repeater Unit has been assigned to the Master Controller, discon-
nect it from the temporary 230V power supply outlet
• Place it somewhere between the Master Controller and the room therm
stat (with the unsatisfactory link test) – see g. 5 – and connect it to a 230V
power supply outlet
• Verify the transmission to the Master Controller by making a link test from
the Repeater Unit – see 4
• Perform another link test from the room thermostat with 1) the
unsatisfactory link test or 2) where system enlargement is required
Note: Extending the transmission range of the CF2 system
• Up to three Repeater Units can be installed in a chain – see g. 5
• Several chains of Repeater Units can be added to one Master Controller
– see g. 5