Bettis Mechanical Installation guide

Bettis
Brand
Bettis
Model
Mechanical
Type
Installation guide
Mechanical Installation procedure of XP Control Modules (QC4x).
5 Place the alignment-edge (1) of the control module at the
top of the pneumatic interface.
Flip the module down taking care that the IPT Probe (2)
on the actuator ts in the mating hole on the control mod-
ule and loosely place the screws.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
6 Tighten screws according to the force - and in sequence
as shown below.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
Control Modules
Installation Instruction
DOC.QC4.MTI.1 Rev. B
October 2015
1 Check if the module has the required function.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
2 Remove the transparent lm.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
3 Ensure seals are placed correctly.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
4 Level the screws with the surface.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
  • Page 1 1

Bettis Mechanical Installation guide

Bettis
Brand
Bettis
Model
Mechanical
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents