2. Bettis
  3. Mechanical

Bettis Mechanical Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Bettis Mechanical Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Mechanical Installation procedure of XP Control Modules (QC4x).
5 Place the alignment-edge (1) of the control module at the
top of the pneumatic interface.
Flip the module down taking care that the IPT Probe (2)
on the actuator ts in the mating hole on the control mod-
ule and loosely place the screws.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
6 Tighten screws according to the force - and in sequence
as shown below.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
Control Modules
Installation Instruction
DOC.QC4.MTI.1 Rev. B
October 2015
1 Check if the module has the required function.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
2 Remove the transparent lm.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
3 Ensure seals are placed correctly.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
4 Level the screws with the surface.
1
2
OK !
1
3
2
6.1 to 6.6 Nm
(54 - 58.4 In.lbf.)
DA
SA
FILP
2
6
4
1
5
3
/