MULTIPLEX Ice Chute Kit Installation guide

Instructions

Manitowoc Foodservice Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: 812-246-7000, www.manitowocbeverage.com

020002680

6/09

Subject: Rocking Chute Kit 020002680

SCOPE

S, SV, SVi, SPA, MDH, SCI, FRP (All units with standard rocking chute ice dispensers)

ACTION

1. Remove power from the unit by unplugging the power cord.

2. Remove dispense switch with wires from left rocking chute mounting bracket.

3. Un-Assemble Rocking Chute assembly from Right and Left Side Mounting brackets, 4 parts (front clip, upper RC

holder, lower RC holder, Ice Dispenser activator/chute).

4. Remove both old Right and Left Rocking Chute Mounting brackets from Foam Front (2 screws each).

5. Screw both New Right and Left Rocking Chute Mounting brackets into place.

6. Re-install dispense switch with wires to new left rocking chute bracket.

7. Screw new cover onto left mounting chute bracket (only) as shown, route wires through opening on bottom flange of bracket.

8. Re-Assemble Rocking Chute Assembly parts (4).

9. Test ice chute to make sure all parts are moving correctly.

10. Restore power to the unit by plugging in the power cord.

FURTHER ACTIONS

• Contact Foodservice Service Sellersburg Indiana if you have any questions or concerns: 800-367-0427.