Shelving
Assembly Instrucons
8’W x 2’D x 7’H
STEP 1
Start by taking inventory of the individual components
you received. This shelving unit arrives in three sepa-
rate boxes. See the component list to verify what you
received. If you are missing any items please contact
SafeRacks support at 877-655-3443.
STEP 2
Take two vercal posts and place them against a wall
or on the oor with the key holes facing down as
shown in Fig 1. Begin adding the 2-foot horizontal
beams at the desired shelf levels. Complete this step
twice so that you have two matching secons of the
shelving unit. See Fig 2.
FIG 1
FIG 3
FIG 2
STEP 3
Locate the 8-foot beams and begin placing them at
the same shelf levels you determined in step 2. See
Fig 4. Add the remaining 8-foot beams at all levels.
See Fig 5. CAUTION: Ensure all rivets are seated rm-
ly into each keyhole. Failure to do this may cause the
shelves to become dislodged.
FIG 4 FIG 5
STEP 4
Using 2 screws and 2 wingnuts at each end, mount the
4 center supports between the 8-foot horizontal
beams. See Fig 6, 7 and 8. Tighten each screw with a
screwdriver.
FIG 6 FIG 8
FIG 7
STEP 5
Place the wire decking on the shelf. Ensure that the
side with more front-to-back wires is facing up. See
Fig 11. Repeat this step unl all remaining wire decks
are in place.
FIG 9
FIG 10
For assistance contact the SafeRacks customer support team at 877-
655-3443 or visit www.SafeRacks.com for more informaon. Our
support sta is available Monday through Friday 7:00am to 5:30pm
and Saturday 8:00am to 12:00pm Pacic Standard Time.
SafeRacks.com or 1-877-655-3443 Copyright © Eagle Industrial Group Inc. 2015-2016 U.S. Patents D553,401 / 7,357,262 / D697,785 / 7,152,535 Other Patents Pending
Page 1