5
Clock
Operating instructions
Dear Customer,
As part of a special manufacturing batch your cooker has already been fitted
with our new clock.
The setting of the time as well the operation of the pyrolytic self-cleaning
function (if fitted to your appliance) is somewhat different to the information
given in the instructions included with your cooker.
Please read how to operate these items in the following instructions.
6
Before using for the first time
Setting the time
The electronic clock display flashes after the electricity supply has been
connected.
You must now set the current time.
To do this do the following:
1. Press button 4 M briefly.
2. Within 5 seconds, set the current time using the + or - buttons.
The time appears on the display. The oven is now ready for use.
Note:
Every time the electricity supply is interrupted, all settings are lost.
In this case you must reset the time again.
N5232_U
1234 5
A
U
T
O
7
Cleaning and care
Pyrolytic self-cleaning (if fitted)
To do this do the following:
1. Set the
function selection switch
to the P symbol.
2. Set the
temperature selection switch
to P.
The time and "PAUTO" are illuminated in the display.
3. Press button
2
<.
"PAUTO" and 1
30 is shown in the display.
4. Within 5 seconds, set the cleaning time to
2 hours and 30 minutes
using the + or - keys.
The oven switches itself on and, at the end of the cleaning time,
switches itself off again automatically.
5. Set the function and temperature selector switches to "0"
and "Off" respectively.
You can also pre-programme the cleaning process, e.g. if the cleaning
process is to performed at night.
To do this do the following:
1.
Set the function selector switch
and
the temperature selector
switch
to the P symbol.
2. Press button
2 < and set the cleaning time to
2 hours and
30 minutes
using the + and - buttons.
Cleaning and care
8
3. Press button 3
>
, and using the
+
and
-
keys set the time
at which the cleaning process is to end.
The oven switches itself automatically on and off. When the
cleaning process is completed, the "AUTO"
T
symbol flashes.
4. Set the function and temperature selector switches to "0"
and "Off" respectively.
Setting the audible signal tone
This clock can be used to set the frequency of the audible signal to
3 different tone positions.
Proceed as follows:
1. Press the
-
button until the changed signal tone sounds
and release.
The frequency is set to the next range.
2. Press the
-
button again until the changed signal tone
sounds and release.
The frequency is set to the next range.
/