Lenco DVP-947BK Owner's manual

Category
Bluetooth music receivers
Type
Owner's manual
DVP-947 BK
Bluetooth
Bluetooth
Bluetooth
Bluetooth
Bluetooth
DVP-947BK
/STOP long press is STOP
Charging the headphone ba ery
Remark:
not be used then.
the headphone and the USB connector to an USB charger (not included) or a PC but you can also use
the USB port of the DVD player (ONLY if the DVD player is powered by the supplied AC adaptor or
Car adaptor).
- To avoid that the DVD player can’t find your Bluetooth headphone, please disable the
low power and must be charged.
- if you find the max headphone level is too low, please increase the volume level on the DVD
player itself.
Connect the DVD Player with the included Bluetooth Headphone
Please follow the below steps to connect your DVD player with the Bluetooth headphone:
1. Press and hold the Power bu
on of Bluetooth headphone and release it when you hear the “
power on” message from the headphone. The headphones power led will ash red/bl
ue.
2. Press the SETUP bu
on on the remote control and navigate to the AUDIO SETUP PAGE,
Go to the BLUETOOTH op
on and switch it
o ON. A Blu
etooth
icon will be displayed on
the right corner of
3. Now go to the SEARCH DEVICE op
on, choose SEARCH and then press the ENTER bu on on
the remote control to ini
te the Bluetooth device search. The player now will show
"Searching...".
4. When "Searching..." is disappeared from the screen, the Bluetooth icon is changed to
you’ll hear a short beep from the headphone and the headphone’s power led will stop
ashing red/blue.
The DVD player is now connected with the Bluetooth headphone.
A on:
t
the screen.
,
en
Last Memory
ON ON
OFF
Last Memory
stopped, powered down or dvd was reinserted.
OFF
ON
BLUETOOTH
GO TO AUDIO SETUP PAGE
SEARCH DEVICE
Enable/Disable the Bluetooth funcon of the DVD player. A Bluetooth icon will be shown in
The right corner of the player if the Bluetooth funcon is enabled.
When selected, the DVD player will search for available Bluetooth devices which are in paring mode.
If the Bluetooth connecon is successfully made, the displayed icon will change to
you can also use other Bluetooth devices like Bluetooth speakers, a Bluetooth car radio or Bluetooth
HiFi set.
Search Device
Remark:
Bluetooth
If you drive for more than 4 hours, do not forget to take the AUX cable and USB cable.
When the headphonehas no power, you can either recharge it through the USB connector
of the DVD player, or you can plug the AUX (3.5mm) cable in your headphone and DVD player
and enjoy the movies without Bluetooth.
Remark:
DVD player
BT Headphone
Baery : Lithium 7.4V 1000mAh
Baery: Lithium 3.7V 250mAh
Playme: ~ 2 hours in D VD mode on
Playme: ~3.5 4.5 hours
Charge me: ~3-4h
Charge me: ~1.5h
DVP-947BK
/STOP
Lang indrukken is STOPPEN
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66
  • Page 67 67
  • Page 68 68
  • Page 69 69
  • Page 70 70
  • Page 71 71
  • Page 72 72
  • Page 73 73
  • Page 74 74
  • Page 75 75
  • Page 76 76
  • Page 77 77
  • Page 78 78

Lenco DVP-947BK Owner's manual

Category
Bluetooth music receivers
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI