DURA 1103485, 1103488, 1103489, 1103502, 1103503, 1103504, 1103505 Installation guide

  • Hello! I've reviewed the Installation Instructions for the Butterfly Valve Gear Operator. This document provides detailed guidance on how to install and adjust the gear operator, including travel stop adjustments. I'm ready to assist you with any questions you may have about the installation process or the device itself.
  • What should I do before installing the gear operator?
    What is the purpose of the adjustment screws?
    Where is the seal face located?
Disclaimer: Products in this specification manual must by regulation be installed by licensed and
registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete
models from their range without prior notification. Dimensions and set-outs listed are correct at time of
publication however the manufacturer/distributor takes no responsibility for printing errors.
Figure 2
Figure 3
Figure 4
Closing adjustment
Opening adjustment
Figure 5
Handle
Notch Plate
Bolts
Figure 1
Seal face
Valve disc
Adjustment
screw
Indicator
Disclaimer: Products in this specification manual must by regulation be installed by licensed and
registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete
models from their range without prior notification. Dimensions and set-outs listed are correct at time of
publication however the manufacturer/distributor takes no responsibility for printing errors.
Figure 7
Worm gear Worm shaft
Figure 6
Housing
cover
Indicator
plate
V1 21.06.23
/