Space Saver 90300 User guide

Brand: Space Saver

Model: 90300

Category: Flat panel wall mounts

Type: User guide

Space Saver 90300 is a full-motion wall mount designed for flat-panel TVs. It is compatible with most TVs weighing up to 50 lbs and has been tested to support televisions on wood studs, brick, and concrete walls. The mount has a variety of features that make it easy to install and use, including a cable management system to keep cords organized and out of the way. The Space Saver 90300 also has a tilting position that allows you to adjust the angle of your TV for optimal viewing.

(Fits most TV sizes weighing up to 50 lbs)

Model: 90300

Questions, problems, missing parts? Before returning to the store,

call STC Customer Service

9 a.m. - 5 p.m., Monday to Friday

Toll Free 1-833-GOSTCNY (1-833-467-8269)

STCNY.COM

Full Motion Wall Mount for Flat Panel TVs

This mount has been tested to

support televisions with maximum

weight as follows: WOOD STUDS,

BRICK,CONCRETE WALLS:

50lbs. (22.7kgs)

Before you begin, carefully read and understand the instructions

in this manual. Please follow the instructions in the order

presented in this manual and observe all warnings and cautions.

16.85"(428mm)

3.15"(80mm)

Toll Free 1-833-GOSTCNY (1-833-467-8269)

Nylon anchor

4 each

8 each

Lag bolt

Screw (size M4x14,M5x14,M6x14,M4x30,M5x30,M6x30,M8x30,M8x50)

Washer (size D5 and D8)

Spacer (size Φ15xΦ8x5 and Φ15xΦ8x15)

NOTE: The hardware included is suitable for

mounting to walls made of brick, solid concrete

using (AA and BB). If your

mounting situation is different, please consult a

qualified installer or contact customer service

at: 1-833-467-8269

D E F G

B C

Wall Mount 1

Cable managementB

VESA adapterC

D Screw

E Nut

F Allen key

G Wrench

Screw is too

long

Screw is too

short

Screw ts

correctly

To ensure proper mounting of the brackets to your

TV, this mounting system includes several sizes

(M4, M5, M6, and M8) of screws (DD).

Select the screw diameter to use by inserting

the various sized screws (M4, M5, M6, and M8)

into the mounting holes in the back of your TV

to identify the right size.

10 20 30 40 50 60 70 80 90 100mm

1 2 3 4in

CAUTION: To avoid potential personal injuries and property

damage, make sure that there are adequate threads to secure the

brackets to your TV. If you encounter resistance, stop immediately and

contact customer service. Use the shortest screw and spacer

combination to accommodate your TV. Using hardware that is too

long may damage your TV. However, using a screw that is too short

may cause your TV to fall from the mount.

Toll Free 1-833-GOSTCNY (1-833-467-8269)

Pull the arm out and then remove the VESA plate and the decorative cover to start assembling.

Arranging the wall plate

Installing the VESA adapter

VESA 100x100,200x100,200x200

VESA 400x200,300x200VESA 300x300,400x400

VESA 400x300

15.74"(400mm)

11.81"(300mm)

15.74"(400mm)

11.81"(300mm)

7.87"(200mm)

11.81"(300mm)

15.74"(400mm)

11.81"(300mm)

7.87"(200mm)

3.93"(100mm)

7.87"(200mm)

3.93"(100mm)

TVs 200 VESA

Attaching the mounting brackets to the TV

CAUTION: Tighten the screws so the brackets

are ﬁrmly attached. DO NOT OVERTIGHTEN. This

may damage your TV.

TVs >200 VESA

Use of the spacers (FF) will vary depending on the type of TV you will be mounting.

Toll Free 1-833-GOSTCNY (1-833-467-8269)

For Plasterboard/ Sheetrock walls mount directly on the board, no stud is required.

PLANNING WALL PLACEMENT

Installing the wall plate (concrete/brick wall)

3 4

Use 1/4 in (6mm) drill bit to drill a pilot holes and then use a 3/8 in (10 mm) masonry drill bit to slowly drill

2.4 in (60 mm) holes.

(10 mm) 3/8”(6 mm) 1/4”

(60 mm) 2.4”

Toll Free 1-833-GOSTCNY (1-833-467-8269)

Installing the decorative cover

Use a commercially-available stud finder to locate the stud centers in the wall. Studs are usually spaced 16 in. apart.

Use a 3/16 in. (4.5 mm) drill bit to slowly drill 2.2 in. (55 mm) pilot holes.

Installing the wall plate (wood stud)

3 4

Mounting the TV to the wall plate

Secure the TV

HEAVY! You will need

assistance with this step.

Managing the cable

Remove the cable management

Pass the cables and connect the cable management back in place

Toll Free 1-833-GOSTCNY (1-833-467-8269)

To adjust the tilting position, release the screws by using the Allen key, adjust the best tilting position

and tight the screws to keep the position.

Adjusting the TV to the desired position

STEP 1: MOVE LEG 1 into the housing. STEP 2: POSITION LEG 2 at the approximate angle

shown to avoid contact with the decorative plate.

STEP 3: MOVE LEG 2 and your TV backward and into the decorative rear housing.

To fold the mount into the decorative rear housing

Questions, problems, missing parts? Before returning to the store,

call STC Customer Service

9 a.m. - 5 p.m., Monday to Friday

Toll Free 1-833-GOSTCNY (1-833-467-8269)

STCNY.COM

Space Saver 90300 User guide

Brand: Space Saver

Model: 90300

Category: Flat panel wall mounts

Type: User guide

Download PDF

report

Space Saver 90300 User guide

Space Saver 90300 User guide

Related papers

Other documents