INSTRUCTIONS
Note: The diagram illustrates the installation of your new luminary. This is a representative drawing and
is not intended to match the style of your luminary.
Assembly:
1. Make sure that your lamp is not plugged into the
electrical outlet.
2. Insert the light bulb “A” (included) into the
socket “B”.
CAUTION - Refer to the wattage caution label
located near the lamp holder for recommended
maximum wattage-do not exceeds recommended
wattage.
WARNING - Do not attempt to replace the bulb
while the lamp is plugged into a wall receptacle.
3. Squeeze the two spring clips "C" and insert them
into the glass shade "D". Please note: The spring
clips are designed to properly hold this style of
shade, make sure you proceed with caution to
avoid getting your fingers pinched.
4. Plug the electrical cord into an outlet and turn on
the lamp with the line switch.
WARNING
Keep this lamp away from small children. It is not a toy.
CARE INSTRUCTION：Dry cloths clean only; do not use water.
Important Safety Instruction
This portable lamp has a polarized plug (one blade is wider than the other)
as a safety feature to reduce the risk of the electric shock. This plug will
fit in a polarized outlet only one way. If it does not fit in the outlet, reverse the
plug. If it still does not fit, consult a qualified electrician. Never use an
extension cord unless the plug can be fully inserted. Do not alter the plug.
/
