Page is loading ...
EASY ASSEMBLY GUIDE
IF YOU HAVE ANY QUESTIONS OR PROBLEMS
PLEASE CALL OUR TOLL FREE HELPLINE
ASSEMBLY GUIDE
888-998-9848
D O N OT R ETURN TO TH E STORE
AP-100 Upright Digital Piano
Legs (2)
1. Begin assembly by attaching the pedal board to the
piano legs. With the pedals facing forward towards the
front of the legs, attach the pedal board using four
Pedal Board Bolts, as shown.
2. Using four Back Panel Screws, and two Back Panel
Bolts, attach the back panel to the stand as shown.
A.
B. C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
1. U
NPACKING
Y
OUR
N
EW
D
IGITAL
P
IANO
A Piano Body x1
B Left Side Leg x1
C Right Side Leg x1
D Back Panel x1
E Pedal Board x1
F Pedal Board Bolts x4
G Piano Body Bolts x6
H Back Panel Bolts w/ Washers x2
I
Back Panel Screws w/ Washers x 4
J Mounting Screws x2
K Headphone Holder x1
L Phillips Screwdriver x1
M Power Supply Cable x1
N USB Audio Cable x1
Unboxing Your New Artesia Piano
Assembling the Piano Stand
(Fig 2.)
(Fig 2.)
(Fig 1.)
(Fig 1.)
4.
Finish attaching the piano to the stand by using the
sixremaining Piano Body Bolts to attach the bottom of
the piano to its stand.
3.
Lift the piano onto the stand and slide forwards,
pushing the guide rods on the bottom of the piano into
the slots on the piano legs.
5.
Attach the AC Power Cord and Pedal Cable into their
connectors on the bottom of the piano as shown.
6.
Turn the Pedal Support Bolt beneath pedals counter-
clockwise until the bolt rmly rests on the oor.
(Fig 4.)
(Fig 5.)
(Fig 5.)
(Fig 6.)
(Fig 6.)
(Fig 3.)
(Fig 3.)
(Fig 4.)
(Fig 4.)
Attaching the Piano Body
Final Set Up
Piano Bench Assembly
If you have any questions about your piano please contact us
toll free at
888-998-9848
Virgin (VMI) is the Parent Company of Artesia Pianos
Virgin Musical Instrument Company
P.O. BOX 2908
LA MESA, CA 91943
info@virginmusicalinstruments.com
www.virginmusicalinstruments.com
To assemble the bench, insert the threaded leg rod through the metal bracket (located on all four corners
underneath of the padded top). Secure each leg with a locking washer and nut, then tighten with the
wrench provided as shown in the picture below.
Padded Bench
Locking Washer (4)
Wrench
Nut (4)
Leg (4)
Locking Washer
Metal Bracket
Leg Rod
Nut
Assembling the Bench
/
