CPS UVC 19 STERI-LAMP User manual

Type
User manual

CPS UVC 19 STERI-LAMP is a UV light disinfection device that can eliminate germs, viruses, bacteria, fungi, molds, and other harmful pollutants from directly exposed surfaces. It features a motion detection sensor to prevent exposure to people and pets. Use it as an adjunct to current cleaning practices in areas such as bathrooms, kitchens, closets, and offices. Choose from 15, 30, or 60-minute timer settings for different space sizes. Remote control operation allows you to set the timer and turn the lamp on/off from a distance.

CPS UVC 19 STERI-LAMP is a UV light disinfection device that can eliminate germs, viruses, bacteria, fungi, molds, and other harmful pollutants from directly exposed surfaces. It features a motion detection sensor to prevent exposure to people and pets. Use it as an adjunct to current cleaning practices in areas such as bathrooms, kitchens, closets, and offices. Choose from 15, 30, or 60-minute timer settings for different space sizes. Remote control operation allows you to set the timer and turn the lamp on/off from a distance.

UVC 19: STERI-LAMP
Product Background:
DISINFECTS PLACES DIRECTLY EXPOSED TO
THE UV LIGHT.
UV LIGHT IS ABLE TO DESTROY THE DNA OF
GERMS, VIRUSES, DISEASE, BACTERIA,
FUNGI, MOLDS AND MANY OTHER HARMFUL
POLLUTANTS WHICH HELPS IT TO NOT
SPREAD.
MOTION DETECTIVE SENSOR PREVENTS
PEOPLE/PETS FROM THE UV LIGHT.
THIS DEVICE IS MEANT TO BE USED AS AN
ADJUNCT TO CURRENT CLEANING
PRACTICES, NOT REPLACING THEM.
Safety:
D0 NOT LOOK AT THE ULTRAVIOLET LIGHT
SOURCE DIRECTLY. SHOULD NOT BE ON
WHEN PEOPLE, ANIMALS, OR PLANTS ARE
IN THE ROOM.
IF LOOKED AT DIRECTLY UV CAN CAUSE
STIGMATA, TIRED EYES, OR CONJUNCTIVE
IRRITATION.
DO NOT RECOMMEND USE IF THE
TEMPERATURE IS BELOW 20°C/68 °F OR
OVER 40°C/ 104 °F.
KEEP DUST AND SPRAY AWAY FROM THE
BULB.
KEEP LAMP 3 FT AWAY FROM CLOTH FOR
DISINFECTION.
** Please note: These products are not
intended to disinfect medical devices.
**UV disinfection will reduce the number of
pathogens but not eliminate them completely
** These devices are not fda 510k cleared.
CPS-UVC-19-SL-500
Steri-Lamp user guide
Name of parts:
1. lamp shade
2. UV lamp
3. Power Plug
4. touch button
5. Base
Operating Information:
When power is on, the working indicator is red.
When you press the power button, the working indicator is green.
Timer indicator is blue.
During the starting procedure, the green light indicator will flash in 10 seconds, giving
the person using it time to leave the room.
During the sterilization procedure the working indicator is in green, timer is in blue.
After sterilization, the working indicator will be red.
The bulb can work for over 8,000 hours
Timer Options:
15 minute mode: Suitable for small spaces such as bathrooms, kitchens, closets, office, etc.
30 minute mode: Applicable for disinfection less than 40 square meters of face.
60 minute mode: Applicable for more than 40 square meters of space.
Remote Control Instruction:
Remote control works within 30 meters wireless (~98 FT).
Remote has the same on/off and timer buttons.
Once you choose your timer setting, after 10 seconds it will turn on automatically.
The lamp is still what will light up not the remote.
Human Detection Instruction:
This product has a 360 degree human-body detection design, while working, it will automatically stop once it
senses a human or animal. Once it senses there is no physical body there anymore it will start working again
after a 10 second countdown.
The detection does not work in the first 30 seconds you start sterilization. After the 10 second warning the
operator needs to leave the room. If you have to re-enter, you need to wait 1 minute and then enter so it will
sense you.
It can sense humans and large animals. It will not sense small animals like mice, bugs, etc.
Caution:
DO NOT look at the ultraviolet light source directly, this product should not be on with people, animals, or
plants in the room. UV light can cause stigmata tired eyes, or conjunctive irritation.
Keep dust and spray away from the bulb.
You might find some white dust or small crystal inside the bulb tube after the lamp working for several times,
this situation is common. The dust or crystal is a kind of oxide of the material when power tum on, and it
would not influence the function at all
Problem Solving:
Problem: The lamp will not turn on.
Solution: Connect the power cable ,the blue indicator light turns on, revolve the protection
anticlockwise to take it off. Press on/off
button (or press the tele-controller) the indicator change
into light, the lamp will raise automatically, indicator twinkling at the same time, and disinfection
will start in the next 10 seconds, UV
lamp working time setting at 30 minutes.
Please insure the bulb tube is inserted correctly and steadily, Turn off the power and check the bulb
tube again.
Problem: The product works well but out of remote control.
Solution: Please check the battery of the controller is assembled in the right position and still have
power or not.
The information and recommendations contained in this publication are based upon data
collected by CPS LED Lighting and are believed to be correct. However, no guarantee or
warranty of any kind, expressed or implied, is made with respect to the information
contained herein. Specifications and information are subject to change without notice.
Although every precaution has been taken in the preparation of this material, CPS LED
Lighting assumes no responsibility for errors or omissions. Neither is any liability
assumed for damages resulting from the use of the information contain herein.
If there is a defect with the lamp please contact CPS LED for
information on replacement options.
YOU CAN LEARN MORE ABOUT UVC ON THE ISO
WEBSITE.
Contact CPS with any further questions.
SAFETY IS KEY.
A L W A Y S T A K E P R E V E N T I V E M E A S U R E S .
The information and recommendations contained in this publication are based upon data collected by CPS
LED Lighting and are believed to be correct. However, no guarantee or warranty of any kind, expressed or
implied, is made with respect to the information contained herein. Specifications and information are
subject to change without notice. Although every precaution has been taken in the preparation of this
material, CPS LED Lighting assumes no responsibility for errors or omissions. Neither is any liability assumed
for damages resulting from the use of the information contain herein.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

CPS UVC 19 STERI-LAMP User manual

Type
User manual

CPS UVC 19 STERI-LAMP is a UV light disinfection device that can eliminate germs, viruses, bacteria, fungi, molds, and other harmful pollutants from directly exposed surfaces. It features a motion detection sensor to prevent exposure to people and pets. Use it as an adjunct to current cleaning practices in areas such as bathrooms, kitchens, closets, and offices. Choose from 15, 30, or 60-minute timer settings for different space sizes. Remote control operation allows you to set the timer and turn the lamp on/off from a distance.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI