Hagerco 9130 Series - Heavy Duty Aluminum - I-Beam Track and Hardware Installation guide

Type
Installation guide
Sliding Door Hardware 9110 & 9130 - By-Pass
Installation Instructions
I-SD00321
Rev 2, Rev Date: 2/13/18 Page 1 of 2
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
1 PREPARE OPENING
OPENING HEIGHT MAX = DOOR HEIGHT + 4-1/4”
OPENING HEIGHT MIN = DOOR HEIGHT + 3-1/2
CONTENTS
9110
9130
1. TRACK (9101)
2. CARRIER
3. DOOR MOUNT PLATE
4. FLOOR GUIDE (9115)
5. #10 X 1-1/2” PPHS
6. #6 X 7/8” FPHS
7. #12 X 1-1/4” PPHS
8. RUBBER BUMPER (9881)
(sold separately)
9. PULL
(Sold separately)
1
2 (9102)
2
1
20
4
8
1
1
1
2 (9105)
2
1
20
4
8
1
1
2. (9105)
4.
3.
1.
2. (9102)
7.
5.
8.
3.
Sliding Door Hardware 9110 & 9130 - By-Pass
Installation Instructions
I-SD00321
Rev 2, Rev Date: 2/13/18 Page 2 of 2
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
2 INSTALL TRACK AND HANGERS
Center track in opening and secure with (#10x1-1/2”) screws
Leave a 1” gap between right end of track and door frame to
allow for carrier removal
Center quick release plates on door thickness
Mount left plate edge 3/4” from near left door edge
Mount right plate edge 1-1/2”” from near right door edge
Secure Carriers onto door with (#12 x 1-1/4”) screws
3 HANG DOORS
4 ADJUST AND FINISH
Cut a continuous kerf in bottom of door for guide
Open quick release latches on brackets
Slide door onto carrier and close hatch
Repeat for front door on front rail
Adjust carriers so door is square with frame
Install door guides in center of opening, where
doors overlap using (#6 x 7/8”) screws
Drill appropriate dimensioned hole to mount door
pull (optional)
Install stops (optional)
  • Page 1 1
  • Page 2 2

Hagerco 9130 Series - Heavy Duty Aluminum - I-Beam Track and Hardware Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI