2. PDQ
  3. 6WS

PDQ 6WS User manual

  • I have analyzed the provided installation instructions for the PDQ 6300R/6300V series exit devices. This document details the step-by-step process for preparing the trim, installing the device, and mounting the control board along with the battery pack. I am ready to address any questions you might have about the content described in this document.
  • How do I prepare the trim for installation?
    What is the next step after preparing the door according to the template?
    How do I install the control board for the rim device?
6WS INSTALLATION INSTRUCTION
FOR PDQ 6300R / 6300V SERIES EXIT DEVICE
1. PREPARE TRIM FOR
INSTALLATION
• Rotate lever to proper orientation for door, install
square drive spindle into back of trim.
3. RIM DEVICE - INSTALL
CONTROL BOARD
• Install control board assembly – feed wire
through slot under circuit board.
• Secure assembly with (4) included wood/
metal screws.
• Make wire connection after control board
is installed. Push extra wire into door
cavity.
2. INSTALL TRIM AND EXIT
DEVICE
▪ Prepare door according to included
template.
▪ Install escutcheon trim onto door while
feeding wire through door.
▪ Install exit device and secure with (4)
included pan head screws.
▪ Rim Device: Install chassis/head cover.
▪ SVR Device: Skip to step 4
WIRE SLOT
Rev0 – 5-26-23
LH/LHR RH/RHR
LH/LHR RH/RHR
MOTOR
WIRE
For Mechanical Concerns:
Phone: 866-874-3662
www.pdqlocks.com
For Mechanical Concerns:
Phone: 866-874-3662
www.pdqlocks.com
4. SVR DEVICE - INSTALL
SPACER & CONTROL BOARD
• Install rod spacer block with (2) included
wood/metal screws – feed wires through
slot in block.
• Install top rod before control board.
• Install control board assembly – feed wire
through slot under circuit board and secure
assembly with (4) wood/metal screws.
• Make wire connections after control board
installed. Push extra wire into door cavity.
• Install Chassis/Head cover
6WS INSTALLATION INSTRUCTION
FOR PDQ 6300R / 6300V SERIES EXIT DEVICE
Rev0 – 5-26-23
6. INSTALL BATTERIES AND
BATTERY COVER
▪ Install batteries and battery cover with
(2) black pan head screws.
5. INSTALL BATTERY PACK
▪ Plug battery wire into control board.
▪ Install battery pack over two studs on
mounting plate and snap battery pack
onto retainers on control board
assembly.
BATTERY
PACK
BATTERY
COVER
WIRE SLOT
ROD
SPACER
BLOCK
CONTROL
BOARD
ASSEMBLY
TOP ROD
BATTERY
PLUG
BATTERY
RETAINERS
/