Ortech ODD-SCK-500 User manual

Brand: Ortech

Model: ODD-SCK-500

Type: User manual

WARNING

Speed Controllers

MODEL ODD-SCK-500

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

Failure to do so can cause death or injury, or damage to property.

If in any doubt about the installation or use of this product, consult a competent technician.

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED TECHNICIAN.

CAUTION

1. Speed Controllers can only be installed by a qualified technician

2. Before installation or maintenance, please read through this instruction manual

Instruction Manual

1-888-543-6473

1-888-541-6474

13376 Comber Way

Surrey BC V3W 5V9

[email protected]

www.ortechindustries.com

375 Admiral Blvd

Mississauga, ON L5T 2N1

OPERATION

INSTALLATION GUIDE

1. Remove the Grille Assembly from the fan

2. Remove five screw A then remove the cover

3. Remove the nut then remove the fan wheel

4. Remove four screw B then disconnect power box and motor

5. Remove screw C then remove the current power box

6. Put the ODD-SCK-500 in the place, fix it with screw

7. Connect ODD-SCK-500 and motor, install motor back to the housing

8. Install fan wheel and cover back to the housing. Fix the fan wheel with nut, then fix the cover with 5 screw.

9. Install Grille Assembly to the fan

The airflow knob adjusts the lower airflow from

100CFM up to the airflow rate of the speed

determined by the toggle switch setting.

Max airflow is HVI Certified performance based on HVI

Procedures 915, 916, and 920. Other airflow reference

performance is based on HVI Procedures 915,916, and 920.

50%

100CFM Max.

75%

Switch

Position

Airflow (CFM) 500 400 300 200

1 2 1 2 1 2 1 2

SCREW B

SCREW C

SCREW A

NUT

Ortech ODD-SCK-500 User manual

Ortech ODD-SCK-500 User manual

Ortech ODD-SCK-500 User manual

Related papers

Other documents