WARNING
LED Ceiling Mounts
MODEL 1701-12 SN | 1702-14 SN
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. LED Ceiling Mounts are suitable for using in damp locations
2. Please keep the LED Ceiling Mounts away from any corrosive substance. Please use dry cloth when you clean it
3. LED Ceiling Mounts can only be installed by a qualified electrician
4. Before installation or maintenance, please disconnect the power to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
www.ortechindustries.ca
205 Summerlea Rd
Brampton, ON L6T 4E5
CAUTION
Application Notice
1. Should be installed by licensed electrician or technician who has electrical knowledge and fully understands the safety requirements
2. Only operate the product with voltage and frequency stated on this instruction manual,
to operate product at different voltage and frequency will affect the lifetime of the product
3. Power MUST be turned OFF during installation and servicing. For indoor use only
ORTECH reserves the right to modify at any time, without notice,
any or all of our product's features, designs, components and
specifications to meet market changes.
•High quality aluminum for PCB (Printed Circuit Board) to achieve best heat dissipation solution
•Professional grade PC material for even light distribution and max. light output
•High performance LED for high CRI, longer life, and high efficiency
•~50% of energy saving for cost effective solution
1. Cover Lens
2. Top Ring
3. LED Board
4. Power Supply
5. Fixture Housing
Product Features
1. Turn OFF the power
2. Remove the cover lens (12) from the fixture housing (10).
Position your fixture over the junction box (1)
3. Pull the supply wires (6) and ground wire out from the junction box (1)
4. Connect the ground wire to the junction box by ground screw (2).
Connect black supply wire (6) to the black fixture wire (8) by using wire
connectors (7). Carefully tuck all wires back into the junction box (1)
5. Locate the fixture housing (10) over the junction box (1).
Put the fixture screw through the long hole slot on the fixture housing
(10) and thread into the junction box (1). Then Secure the fixture housing
(10) to the junction box (1) by tightening the two fixture screws (13)
6. Secure the cover lens (12) and the top ring to the fixture housing
Assembly Instructions
1) Junction box
2) Ground screw
3) Fixture ground wire
4) White supply wire
5) White fixture wire
6) Black supply wire
7) Wire connector
8) Black fixture wire
9) LED board
10) Fixture housing
11) LED drive
12) Cover lens
13) Fixture screw
14) Top ring
-
1
Ortech 1702-14SN User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
RAB Lighting SHARK4-50W/480/D10/LC Operating instructions
-
RAB Lighting IVAT2-45LWM750GU/7PR/LC Operating instructions
-
RAB Lighting IVGT5-50L750WU/LCE2 Operating instructions
-
RAB Lighting BAYLED78YW/D10/LC Operating instructions
-
-
RAB Lighting WP3LED55NW/480/LC Operating instructions
-
RAB Lighting ALED4T150NW/D10/LC Operating instructions
-
RAB Lighting ALED2T260YW/D10/LC Operating instructions
-
-