Ortech 1701-12SN User manual

Brand: Ortech

Model: 1701-12SN

Type: User manual

This manual is also suitable for

1702-14SN

WARNING

LED Ceiling Mounts

MODEL 1701-12 SN | 1702-14 SN

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

Electrical products can cause death or injury, or damage to property.

If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

1. LED Ceiling Mounts are suitable for using in damp locations

2. Please keep the LED Ceiling Mounts away from any corrosive substance. Please use dry cloth when you clean it

3. LED Ceiling Mounts can only be installed by a qualified electrician

4. Before installation or maintenance, please disconnect the power to prevent electric shock

Instruction Manual

1-888-543-6473

1-888-541-6474

13376 Comber Way

Surrey BC V3W 5V9

[email protected]

www.ortechindustries.ca

205 Summerlea Rd

Brampton, ON L6T 4E5

CAUTION

Application Notice

1. Should be installed by licensed electrician or technician who has electrical knowledge and fully understands the safety requirements

2. Only operate the product with voltage and frequency stated on this instruction manual,

to operate product at different voltage and frequency will affect the lifetime of the product

3. Power MUST be turned OFF during installation and servicing. For indoor use only

ORTECH reserves the right to modify at any time, without notice,

any or all of our product's features, designs, components and

specifications to meet market changes.

•High quality aluminum for PCB (Printed Circuit Board) to achieve best heat dissipation solution

•Professional grade PC material for even light distribution and max. light output

•High performance LED for high CRI, longer life, and high efficiency

•~50% of energy saving for cost effective solution

1. Cover Lens

2. Top Ring

3. LED Board

4. Power Supply

5. Fixture Housing

Product Features

1. Turn OFF the power

2. Remove the cover lens (12) from the fixture housing (10).

Position your fixture over the junction box (1)

3. Pull the supply wires (6) and ground wire out from the junction box (1)

4. Connect the ground wire to the junction box by ground screw (2).

Connect black supply wire (6) to the black fixture wire (8) by using wire

connectors (7). Carefully tuck all wires back into the junction box (1)

5. Locate the fixture housing (10) over the junction box (1).

Put the fixture screw through the long hole slot on the fixture housing

(10) and thread into the junction box (1). Then Secure the fixture housing

(10) to the junction box (1) by tightening the two fixture screws (13)

6. Secure the cover lens (12) and the top ring to the fixture housing

Assembly Instructions

1) Junction box

2) Ground screw

3) Fixture ground wire

4) White supply wire

5) White fixture wire

6) Black supply wire

7) Wire connector

8) Black fixture wire

9) LED board

10) Fixture housing

11) LED drive

12) Cover lens

13) Fixture screw

14) Top ring

Ortech 1701-12SN User manual

Brand: Ortech

Model: 1701-12SN

Type: User manual

This manual is also suitable for

1702-14SN

Download PDF

report

Ortech 1701-12SN User manual

This manual is also suitable for

Ortech 1701-12SN User manual

Related papers

Other documents