3
Description Symbol Information
Drill Use 4mm drill bit to screw fence board to Slimline post. .
Aluminium Saw Use a ne tooth aluminium saw with
a clean, sharp blade if you wish to cut the boards to length.
Sealant Fix top caps and angles to fence boards.
Rubber Mallet Use a rubber mallet for securing slats on top of each other
and the top cap onto the last slat
Bolt-Down 4 x M12 bolts required to x
each bolt-down post - see number 11 for depending on terrain.
Concrete-In Place 600mm into the ground.
4
Max. 70mm
Bolt Down Option. Allow post centres
of 1800mm.
Concrete-In Option. Allow post
centres of 1800mm.
Choose distance between fence
boards and x next board to post.
Allow no more than 70mm from the
top of the fence to the screw centre.
Fix top board to the top of the
Slimline post
Use rubber mallet to t the end cap
at the end of a run.
Create a corner by overlapping one
board in front of the other.
Use a rubber mallet to connect two
boards together with inline connector
3
6
1 2
5
7 8
Target
Height
No. of
Boards
No.
of
Gaps
Size
of
Gap
Actual
Height
for
Fence
1200 7 6 25 1200
6 5 60 1200
5 4 110 1230
1800 12 11 0 1800
11 10 15 1800
10 9 35 1815
9 8 60 1830
8 7 90 1830
7 6 130 1830
See table for gap sizes
PARALLEL
