Greenheck 482875 Alignment Plate Operating instructions

Aignment Plate Installation 1

Document 482875

Alignment Plate Installation

Models: SEH-401, SED-401, EDJ-401, EDK-402, ESK-402,

EDK-430, ESD-403, ESD-435, ESJ-401, ESD-435X

Alignment Plate #508291

Installation, Operation and Maintenance Manual

Please read and save these instructions for future reference. Read carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself and others by observing all safety information. Failure

to comply with these instructions will result in voiding of the product warranty and may result in personal injury

and/or property damage.

Front View

Alignment Plate Installation2

SEH-401, SED-401

EDJ-401, EDK-402, ESK-402

EDJ-430, EDK-430 ESD-403

Step 1

Units that are to be field stacked will be shipped with alignment

plate(s) to be field installed. Remove the appropriate amount of

blade screws that hold the blade nearest the splice joint of the

mating section (reference model details).

Step 2

Stack the sections together.

Step 3

Attach plates by re-installing blade screws through alignment

plate(s), through jambs, and into screw bosses that are extruded

in blades.

INSTALLATION GUIDELINES

As a result of our commitment to continuous improvement, Greenheck reserves the right to change speciﬁcations

without notice.

Product warranties can be found online at Greenheck.com, either on the speciﬁc product page or in the literature

section of the website at Greenheck.com/Resources/Library/Literature.

Phone: 715.359.6171 • Fax: 715.355.2399 • Parts: 800.355.5354 • E-mail: [email protected] • Website: www.greenheck.com

Our Commitment

ESD-435 ESJ-401

ESD-435X