Greenheck 468788 Splice Angle Operating instructions

Splice Angle Installation 1

Document 468788

Splice Angle Installation

Models: EDD-401, EDD-601, EDJ-401, EDJ-430, EDJ-601, EDK-402, EDK-430, EHH-401,

EHH-501, EHH-601, EHH-701, ESD-403, ESD-435, ESD-603, ESD-635, ESJ-401,

ESJ-602, ESK-402, SED-401, SED-501, SEH-401, SES-401

Installation, Operation and Maintenance Manual

Please read and save these instructions for future reference. Read carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself and others by observing all safety information. Failure

to comply with these instructions will result in voiding of the product warranty and may result in personal injury

and/or property damage.

As a result of our commitment to continuous improvement, Greenheck reserves the right to change speciﬁcations

without notice.

Product warranties can be found online at Greenheck.com, either on the speciﬁc product page or in the literature

section of the website at Greenheck.com/Resources/Library/Literature.

Phone: 715.359.6171 • Fax: 715.355.2399 • Parts: 800.355.5354 • E-mail: [email protected] • Website: www.greenheck.com

Our Commitment

Step 1

Attach the 36" angle splice to the lower section with 18" above the lower section. (See "TOP VIEW" for orientation of angle splice.)

Step 2

Drill 3/8" holes in the support angle on both the upper and lower sections to match with the 36" splice angle.

Step 3

Attach the splice angle with 5/16" bolts. Six (6) bolts per splice angle are required.

NOTE: Please reference the Alignment Plate IOM if alignment plates are to be field installed.

INSTALLATION GUIDELINES

Top View

These fasteners supplied by Greenheck

025 5/16-18x1 HH ZP CS

456 5/16-ZP Spin-Lock Nut

108 #10-16 x3/4 TPH 18-8 SS