888-45-204-W-00rev. D • 01/14
2 of 5
1
5.63”
(143 mm)
6.93”
(176 mm)
1.38”
(35 mm) Ø 0.43”
(11 mm)
2.64”
(67 mm)
Back View
5’3”-5’9”
(160-175cm)
21”
(533 mm)
27.25”
(692mm)
< 26.25”
(667mm)
5’3”-5’9”
(160-175cm)
21”
(533 mm)
31.5”
(800mm)
< 30.5”
(775mm)
Combo Arm With Worksurface
Combo Arm Without Worksurface
Combo Arm Extender
6”
(152 mm)
29.2”
(741mm)
13.7”
(347mm)
8.3”
(211mm) 4.1”
(105mm)
33.7”
(856mm)
24.5”
(621mm)
24.5”
(621mm)
33.7”
(856mm)
25.8”
(656mm)
33.6”
(854mm)
0.28”
(7mm)
29”
(734mm)
10” (252mm)
4.4”
(122mm)
7.7”
(196mm)
30”
(759mm)
20.6”
(524mm)
20.6”
(524mm)
30”
(759mm)
26”
(622mm)
33.4”
(848mm)
0.08”
(2mm)
ENGLISH
NOTE: Fasteners may unwind due to vibration caused by movement of mounting solution over time. Inspect mounting
solution for loose fasteners on a routine basis. If desired, apply a light duty thread locking adhesive to fasteners before
installation to prevent back-out.
Mounting Height for Ergonomic Workstation
This mounting height is a recommendation for an ergonomic workstation that accommodates user heights of 5’3”-5’9” (160-175cm).
If user heights are di erent than this, you should change mounting height to accommodate user heights. (Change mounting height
one inch for every one inch di erence in user heights).
Mounting height assumes there is a 6” (152 mm) distance between the center
of your monitor mounting holes and the top of the screen. If your distance is
smaller, you should increase mounting height accordingly, if your distance is
larger, you should decrease your mounting height accordingly.
Determine mounting location:
Determine mounting location:
Top view showing range of motion when pulled out
from the wall.
Front view with arm pushed back against the wall.
Front view with arm pushed back against the wall.