CP-MAPSII-RHXG (10-18) PN209812R1
1
Revision: CP-MAPSII-RHXG (10-18) PN209812R1
REPLACEMENT HEAT EXCHANGER FOR MODELS RDCA AND RDDA
GASKET KIT INSTALLATION INSTRUCTIONS
Supersedes: CP-MAPS II-RHXG (11-06) Version A
Replacement heat exchangers require new gaskets. To prevent damage during shipping or storage, gaskets for
replacement heat exchangers are shipped in a parts bag for field installation.
⚠ DANGER ⚠
• The replacement heat exchanger should be installed by a qualified service agency in compliance
with all codes and requirements of authorities having jurisdiction.
• Improper installation could result in death, serious injury, and /or property damage. The qualified
agency performing this work assumes responsibility for this installation.
COMPONENT SELECTION
Gas heat section sizes 100–400 have one heat exchanger. Gas heat section sizes 450–700 have two heat exchangers.
Refer to the components listed in the table below to select the right gasket kit for the heat exchanger.
NOTE: Each gasket kit listed in the table below is for one heat exchanger.
Component & Location
Gas Heat Section
100 150 200 250 300 350 & 400 450 & 500 550 & 600 650 & 700
Gasket Kit PN
209754 209755 209756 209757 209758 209759 209760 209761 209762
PN (Quantity)
Header gasket for header
sides
204547 (2) 208139 (2)
Header gasket for header
top and bottom
204542 (2) 204543 (2) 204544 (2) 204545 (2)
204546 (2)
208138 (2) 208135 (2) 208136 (2) 208137 (2)
205587 (2)
Collection box gasket for
collection box sides
204626 (2) —
Collection box gasket for
collection box top and
bottom
204621 (2) 204622 (2) 204623 (2) 204624 (2) 204625 (2) —
One-piece gasket for
collecton box top, sides,
and bottom
— 220846 (1) 220847 (1) 220848 (1) 220849 (1)
INSTALLATION
⚠ WARNING ⚠
Proper installation and sealing of the heat exchanger to the unit is necessary for reliable and safe
operation. Failure to properly install could result in property damage, personal injury, and/or death.
⚠ CAUTION ⚠
Verify that the gasket kit is the right one for the heat exchanger.