IMPORTANT:
Go to www.extron.com for the complete
user guide,
installation instructions,
and
ore connecting the
pr
wer source.
HDP1014K • Setup Guide
The Extron HDP 101 4K is a compact, active HDMI to DisplayPort converter for signals up to
4K 30 Hz @ 4:4:4, providing connectivity between HDMI sources and DisplayPort displays and
peripherals. Follow these instructions to install the HDP 101 4K.
Cabling
DP OUT
SIG
POWER
12V
0.1A MAX
HDP 101 4K
L
CONFIG
HDMI IN
A
BD
HDP 101 4K
L
CONFIG
HDMI IN
DP OUT
SIG
POWER
12V
0.1A MAX
C
A
Config port − Connect a host computer to this USB port to configure the HDP1014K.
NOTE: Use Product Configuration Software (PCS) or Simple Instruction Set™ (SIS™)
commands in DataViewer to configure EDID Minder
®
, adjust the format and video
color bit depth, and monitor the signal status (see the HDP1014K User Guide at
www.extron.com).
B
HDMI input − Connect an HDMI source device to the HDMI input.
C
Power inlet − Wire the power supply as shown below and connect it to the power inlet.
SECTION A–A
Ridges
Smooth
Power Supply Output Cord
A
A
3/16"
(5 mm) Max.
ATTENTION:
• Do not connect any external power supplies until you have read the Attention
notications in the Power Supply section of the HDP1014K User Guide.
• Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises en
garde dans la section «PowerSupply» du guide HDP1014K utilisateur.
D
DP output − Connect a DisplayPort output device to the DP output.
LED Indicators
A
Power/signal LED − Lights amber
to indicate power, and lights green
to indicate HDMI signal presence.
B
Output signal LED (rear panel) −
Lights to indicate signal presence
on the DisplayPort output.
DP OUT
SIG
POWER
12V
0.1A MAX
HDP 101 4K
L
CONFIG
HDMI IN
A BD
HDP 101 4K
L
CONFIG
HDMI IN
D
DP OUT
SIG
POWER
12V
0.1A MAX
A
B