2. Toro
  3. Spool Carrier Kit, Dingo Compact Utility Loader

Toro Spool Carrier Kit, Dingo Compact Utility Loader Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Spool Carrier Kit, Dingo Compact Utility Loader Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Form No. 3324-932
Spool Carrier Kit
Part No. 104-2661
Installation
Instructions
Dingo
200/300 Series Compact Utility Loader
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Spool carrier
Lynch pin, rectangular retainer
Mounting tube
U–bolt
Flange nut
1
1
1
1
2
Installing the spool carrier
Secondary spool carrier
Lynch pin, rectangular retainer
1
1
Installing the secondary spool carrier
Spool of wire (not included with the kit)
Washer
Lynch pin, semi–circular retainer
1 or 2
4
2
Installing spools
Brake strap
Brake cover
2
2
Installing the spool brakes
Installing the Spool Carrier
1. Place the U–bolt around the right loader arm, behind
and touching the crossbar, as illustrated in Figure 1.
2
m–5337
2
1
3
4
5
5
7
8
6
7
7
78
9
9
Figure 1
1. U–bolt
2. Mounting tube
3. Flange nut
4. Spool carrier
5. Lynch pin with rectangular
retainer
6. Secondary spool carrier
7. Washer
8. Spool (not supplied)
9. Lynch pin with
semi-circular retainer
2. Slide the two small tubes in the mounting tube over
the ends of the U–bolt and secure it with 2 flange nuts
(Fig. 1).
3. Place the spool carrier into the mounting tube,
orienting the horizontal tube on the carrier parallel
with the crossbar on the traction unit (Fig. 1).
4. Secure the spool carrier to the mounting tube with a
lynch pin with a rectangular retainer (Fig. 1).
Installing the Secondary Spool
Carrier
1. Slide the secondary spool carrier into the side hole in
the top of the spool carrier (Fig. 1).
2. Secure the secondary spool carrier with a lynch pin
with a rectangular retainer (Fig. 1)
Installing Spools
1. Place a washer over the end of the spool carrier or
secondary spool carrier (Fig. 1).
2. Slide the spool onto the carrier (Fig. 1).
3. Secure the spool with a washer and a lynch pin with a
semi–circular retainer (Fig. 1).
Installing a Spool Brake
(Optional)
If you have problems with the spools freewheeling and
unwinding on the carrier, install the spool brakes.
1. Slide a brake cover over a brake strap (Fig. 2).
m-5236
2
1
Figure 2
1. Brake strap with brake
cover installed
2. Bracket on the spool
carrier
2. Remove the lynch pin securing the spool to be braked.
3. Install a hook on the brake strap through one of the
holes from where you removed the lynch pin (Fig. 2),
orienting the brake cover as follows:
• If your spool is made out of plastic, place the cloth
side of the cover against the spool.
• If your spool is made out of wood, place the plastic
side of the cover against the spool.
4. Hook the free hook of the brake strap to the bracket on
the spool carrier (Fig. 2).
/