TO BE REMOVED BY THE CUSTOMER AFTER iNSTALLATiON JS COMPLETE
[] INSTALLATION CHECKOFF LIST
Doors ice Maker
[] Door seals completely to cabinet on aHsides
[] Freezer door is UeveUacross the top
Leveling
[] Refrigerator is level, side to side and tilted 1/4" (6mm) front to back
[] Toe grille is property attached to refrigerator
[] Cabinet is setting solid on aHcorners
Electrical Power
[] House power turned on
[] Refrigerator plugged in
[] House water supply connected to refrigerator
[] No water leaks present at all connections - recheck in 24 hours
[] Ice Maker is turned ON.
Final Checks
[] Shipping material removed
[] Fresh Food and Freezer controls set
[] Crisper Humidity controls set
[] Registration Card sent in
HAND TRUCKING
, Load refrigerator from side of
cabinet only.
Do not run retaining straps over
handles.
Do not over-tighten retaining straps.
Never use refrigerator handles to
move the refrigerator.
Remove tape from doors only after
unit is in place.
f -.
INSTALLATION CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top.......... 3/8"
, Back ....................... 1"
NOTE: If you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and wall to allow for
the door to swing open.
ON
Signal Arm
,_ Ensure!ce_ke_!sturnedON:
SHiPPiNG MATERIAL
2 PIECESOF TAPE
1 SHELF SPACER
TOE GRILLE .........
2 PUECESOF FOAM
AND TAPE
2 PIECESOF TAPE_
1 PUECEOF TAPE
2 PIECESOF TAPE J
4 PIECESOF TAPE
2 PIECESOF "[APE
2 PIECESOF FOAM _
LEVELING AND ADJUSTING
All four corners of refrigerator must rest firmly on a solid
floor.Your refrigerator has adjustable rollers to help level it
and to adjust the doors.
To level cabinet or change door height:
1. Remove toe grille.
2. Use a screwdriver, 3/8"wrench, or nutdriver to adjust the
rollers.To raisecabinet, turn screw clockwise.To lower
cabinet, turn screw counterclockwise.
1 PnECEOF TAPE
......1 PIECE OF TAPE
2 PIECESOF TAPE
2 PIECESOF TAPE
Remove Shipping material (Features may vary per model.)
f
Tools You Will Need:
(Vea el otro lado para la versin espa5ol.)
OR
moving refrigerator eut for charting. }
WATER SUPPLY
Connect water supply =check for water leaks. Turn icemaker OFF
if water supply is not connected immediately. Connecting to
a reverse osmosis system is not recommended.
r
When changing CONTROLS, wait 24 hours _ /
before making additional adjustments. \
_._--_Top Hinge tPin yOU to remove the
if need
_-_--_--<3_cover doors to get your refrigera-
' Center tot into the house please see
- _ Hinge "Door Removal Instructions"
-_-__"__r_.__ttor n ', in your Use& Care GuideTop Hinge
//'1_____'_ ,.\X _, Hinge
"'_ _ 'Wood Block
See "Normal Operating Sights & Sounds" in-meUse & Care Manua/so
you understand the sounds you may near once your refrigerator is
running.
Please read entire Use & Care Manual to become aware of imooRam
safety instructionsand to become familiar witrh your ne_ refrigerator.
_, Send in Registration card tc register your refrigerator.
_, Congratulations! You are reaay to enjoyyour newrefrigerator
IFYOU ARE DISSATISFIED WiTH THE _NSTALLAT_ON, PLEASE CALLTHE STORE YOU PURCHASED IT FROM. P/N:241567800