21
II
A N T I - I N T R U S I O N A L A R M
Operation of the alarm
First make sure that all the vehicle’s doors are
closed.
The alarm is armed by pressing button A on the remote
control.
When the alarm is armed, the protections become
(volumetric).
Provided the alarm is armed, any intrusion triggers the
siren for 30 seconds, accompanied by the illumination
of the direction indicators.
The alarm then reverts to armed status, but the
deployment remains memorised and is signalled by
2
you press the unlocking button B
The siren is also triggered if there is a cutting out of
the electrical supply. To stop it, restore the electrical
supply then press the unlocking button B.
Note:
• If you wish to lock your vehicle without arming the
alarm, just lock the vehicle with the key.
• If you try to lock your vehicle when a door or the
boot is still open, the central locking will not operate,
but your alarm becomes armed after approx. 45
seconds.
Note: the siren is automatically disarmed (for example
if you need to disconnect the battery) immediately after
you unlock the vehicle using the remote control.
Deactivation of volumetric detection
protection if you deactivate the volumetric protection
vehicle).
on control 1 for at least one second.
2
Arm the alarm by locking your vehicle using the remote
control.
Automatic activation (depending on country)
The alarm arms automatically 2 minutes after the boot
or the last door is closed.
In order to prevent the alarm then being triggered
by a door or the boot being opened, it is essential to
press again on the unlocking button B on the remote
control.