Programmation tips
Assembly the lintel attachement lug.
Add 50 mm above the highest point on the door travel.
Centred the lug relative to the center of the door.
Assembly
®
50mm
36mm
AXORN 50 AXORN 70 AXORN 90
The rail is delivered with a chain tension that has been pre-set at the factory
Don’t touch this tension.
Check that the rails join correctly. Note the marking (center)
on the assembly bars.
Press and hold the remote control button the press the adjustement push-
button briefly to memorise the remote control buttons.
➔It is possible to memorise either one or two keys per remote control unit :
one to operate the garage door and the other for the light.
When the remote control is memorised, don’t move the garage door.
Move the trolley towards the handle by this method :
The adjustment indicator is on when you put on the AXORN
Lock the handle
Press the adjustment push button
Press and hold the speed push-but-
ton ( change of direction with
each push)
Press the adjustment push-button
again to finish the adjustment pro-
cess.
the adjustment indicator flashes.
The mobile trolley moves
towards the doors and automati-
cally clips onto the handle.
the door is in the closed position
Adjustment push-button
Speed push-button
1 sec
1 sec
1 sec
aintaining pressure
1
1
2
3
4
1
2
3
4
1
maintaining pressure
Adjustment
1
Memorising remote control buttons
2
The garage door must be closed to make the self-learning
Choice of the speed
Press the speed push-button.
Recommandations :
Fast speed recommanded to doors in sections (light on)
Slow speed recommanded to overhanging door (light off)
Waiting the fully closed of the door
If the closing is not total, make the self learning again.
Self learning phase
Press the adjustment push-button
Press the remote control button
memorised earlier.
Press the remote control button
again
The adjustment indicator flashes
The door opens to memorise the
travel to open fully
The door closes to memorise the
travel to close.
1
2
1
2 3
1
2
2
3
1
Self-learning phase
3
®
Erasing the memorised remote control units
Hold down the adjustement and speed
buttons simultaneously for more than 3
seconds.
Memorising remote control
Make the memorising remote control
button. The motor control button must
be the same for the other remote control
units.
The indicators will flashes to indi-
cate that the command has been
taken into account, then go out
after erasing.
> 3 sec
Non-binding document. products and references in this document are subject to change without prior notice.
Somfy S.A.S. - Capital de 20 millions d'Euros - RCS Bonneville 303 970 230.
© SOMFY 04 / 2002
Useful reminder
4
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Somfy Dry Contact Interface Operating instructions
-
-
-
-
-
-
-
-
-
Other documents
-
BFT Tiziano Owner's manual
-
NiceHome AVIO Owner's manual
-
-
CITROEN Citroen C4 Picasso Dag 2007 Owner's manual
-
-
-
BMW 320d xDrive Owner's Handbook Manual
-
CAME V700E Installation guide
-
Peugeot 2007.5 Peugeot 307 SW Owner's manual
-
