V 4.0 24 in. Power Sweeper Brush 8630063
SPECIFICATIONS
Contents 12x Brush 2 (4), 2x Brush 1 (6)
Use With
Power Sweeper 8617409
ASSEMBLY & INSTALLATION
DISASSEMBLY
When this manual refers to a part number, it refers to the included Parts List in the manual of the power
sweeper 8617409.
WARNING! Drain all fluids from the engine before performing any maintenance to the unit.
1. Tilt the machine back making sure that it is properly supported.
2. Unscrew the M10*30 bolt (1) with a 16mm wrench and remove the brush guard (3).
3. Remove the six brush II (flat) and the five brush sleeves (5) in turn.
4. Remove the last brush I (curved) (6).
5. Repeat the process for the opposite side.
24 in. Power Sweeper Brush
Visit www.princessauto.com for more information 1
8630063 24 in. Power Sweeper Brush V 4.0
ASSEMBLY
1. Slide a brush I (curved) (6) first over the brush shaft weldment (7) and then slide the brush sleeve (5)
and the remaining six brushes II (flat) (4) and five brush sleeves (5) onto the brush shaft weldment (7).
NOTE: A brush sleeve (5) must be attached between each brush.
2. Replace the brush guards (3) making sure to line up the brush’s pin roll into the gaps of the brush
guard (3) when installing the final brush and secure with the M10*30 bolt (1) using the 16mm wrench
to tighten firmly.
2 For technical questions call 1-800-665-8685
Page is loading ...
Page is loading ...
/