2. Phoenix Gold
  3. ZDAPB1
ZDAPB1

Phoenix Gold ZDAPB1 User manual

  • Hello! I've reviewed the user manual for the PHOENIX GOLD ZDAPB1 car audio amplifier. This document provides detailed instructions for installing the amplifier in BMW 3-Series vehicles, covering stereo removal, cable connections and fiber optic cable handling. I'm ready to assist with your questions about the installation process or its features.
  • What BMW models are covered by this manual?
    What should I check before installing the amplifier?
    What tools are required for installing the amplifier?
    What should I do if there is a fiber optic cable in the original quadlock connector?
ZDAPB1
•2005 -2012
•E90/E91/E92/E93
•Basic Sound System
•Before installing check
placement of the amplifier. If the
amplifier is to be installed in the
trunk a separate 5m cable i
required.
•If it is to be installed under the
passanger seat, check that there
is room.
BMW 3-Series
(E90/E91/E92/E93)
•Use a plastic pry tool on the
outer edge of the plastic panel to
pop it out.
Stereo Removal 1
•The panel is now loose. Either
unplug the connectors on the
back of the panel or put it to the
side.
Stereo Removal 2
Tools required:
•PH2 Screwdriver
•Loosen the two screws marked
with red circles. Then the stereo
is loose and ready to be taken
out.
Stereo Removal 3
•Remove the quadlock connector
and the fakra connector from the
stereo.
Stereo Removal 4
•OBS! If there is a fiber optic
cable in the original quadlock
connector (the green wire and
the green wire with black wire
loom om) then that cable
needs to be transfered to the
new quadlock connector.
•If there is no such cable skip to
Cable installation 3.
Cable Installation 1
•Under the fiber optical cable the
is a little lock. Use a small flat
screwdriver or something tiny to
loosen the connector.
Cable Installation 2
•Connect the T-ISO harness.
Cable Installation 3
•Connect the fiber optical cable
to the new quadlock connector.
•If you do not have a fiber optical
cable skip to the next step.
Cable Installation 4
•Connect the ISO connectors to
the ZDAISOT cable harness.
Cable Installation 5
•Take the ZDAISOT cable and run
it behind the inner plastic panel
behind the stereo.
Cable Installation 6
Tools required:
•T20 Torx Screwdriver
•Remove the panel under the
glovebox by removing the two
screws.
•Pull out the cable between the
panels.
•Continue to pull the cable either
to under the passanger seat or
the the trunk.
Cable Installation 7
/