4
STEP 3
Insert cam lock nuts (K) into le and
right panels. Fit panels to the front
panel with the cam lock nuts facing
in, then tighten nuts with a Phillips
screwdriver.
NOTE: Panels (C) and (D) should be
flush with panel (B) on side shown.
STEP 4
Insert and tighten cam lock screws (J) into rear two holes of bottom panel (E).
Insert cam lock nuts (K) into le and right panels. Fit top panel (F) and bottom
panel to assembly and tighten cam lock nuts. The top panel simply rests over
the pins.
STEP 5
Attach wall brackets (I) to shelves (A) using ST4x16 screws (N) and tighten
with a Phillips screwdriver. Use pre-drilled locations if mounting to drywall.
If mounting to wood studs, adjust locations to align with studs (a 3/32” or
2.5mm drill bit may be used to create new pilot holes). We recommend
that at least two brackets on each shelf be aligned with studs for wood stud
mounting.
D
C
B
Flush
Flush