Öhlins Front Fork Kit for Gas Gas EC 250/300 with Sachs Front Fork
FGGG 1283
Application Specific Mounting Instructions
Issued 2011-12-14
Kit Contents (application specific)
Recommended Tools (application specific)
Hydraulic Stop Cup
Set-Up Data
Spring Recommendation
Part No. Pcs.
Front Fork kit FGGG 1283 1
Base plug (with o-rings) 15430-07 2
Spacer 2 mm 15443-02 6
Hydraulic Stop Cup 15456-03 2
Spring Support washer 15450-01 2
OEM Fork Cap tool, Socket 50 mm decagon
ALLEN KEY for OEM Base Plug 19 mm
Socket for Öhlins Base Plug 22 mm
FGGG 1283 Cartridge kit comes with a Öhlins Hydraulic stop
cup and a spring support washer. Stop cup shall be installed
according to step 10 and support washer according to step 12
in the “Owners manual and general mounting instructions”.
Rebound Damping 15 clicks
Compression Damping 15 clicks
Spring Preload 2 mm
Fluid Volume (each leg) 0,280 litre
Cartridge Kit FGGG 1283 shall be used together with
Öhlins Front Fork Springs part no. 08762-xx. For rate
recommendations, see Owner’s Manual/ General Mounting
Instructions.
Note!
The fork springs need to be ordered separately depending on the
rider’s choice of spring rate.
Part No. Pcs.
Circlip 15440-01 2
Öhlins Sticker 00192-01 2
TTX Cartridge Sticker 00191-29 2
Owners Manual 07296-90 1
Spring preload range -2 to 8 mm
(can be adjusted by adding/removing washers 15443-02)
Fluid volume range (each leg) 0,250 - 0,350 litre
Öhlins Front Fork uid 01312-01
/