Öhlins Front Fork Kit for Gas Gas EC 300 with Marzocchi 48 Fork
FGGG 1282
Application Specific Mounting Instructions
Issued 2011-11-14
Kit Contents (application specific)
Recommended Tools (application specific)
Hydraulic Stop Cup
Set-Up Data
Spring Recommendation
Part No. Pcs.
Front Fork kit FGGG 1282 1
Base plug (with o-rings) 15430-03 2
Spacer 2 mm 15443-02 10
Tread insert 15458-01 2
O-ring for thread insert 00338-83 4
OEM Fork Cap tool, Socket 49 mm octagon
Socket for OEM Base Plug 19 mm
Socket for Öhlins Base Plug 20 mm
FGGG 1282 cartridge kit uses STD/OEM Hydraulic stop cup,
but a tread insert has to be been installed. Tread insert with
o-rings shall be installed according to step 10 in the “Owner
manual and General mounting instructions”.
Rebound Damping 15 clicks
Compression Damping 15 clicks
Spring Preload 1 mm
Fluid Volume (each leg) 0,370 litre
Cartridge Kit FGGG 1282 shall be used together with
Öhlins Front Fork Springs part no. 08763-xx. For rate
recommendations, see Owner’s Manual/ General Mounting
Instructions.
Note!
The fork springs need to be ordered separately depending on the
rider’s choice of spring rate.
Part No. Pcs.
Circlip 15440-01 2
Öhlins Sticker 00192-01 2
TTX Cartridge Sticker 00191-29 2
Owners Manual 07296-90 1
Spring preload range -2 to 8 mm
(can be adjusted by adding/removing washers 15443-02)
Fluid volume range (each leg) 0,250 - 0,400 litre
Öhlins Front Fork uid 01312-01
Thread insert
Base plug
/