Triton Systems FT7000XP Series Owner's manual

Brand
Triton Systems
Model
FT7000XP Series
Type
Owner's manual

This manual is also suitable for

POWER CORD INSTALLATION GUIDE
(RL2000, FT5000
XP
, FT7000)
NOTE
The Power Cord interface cable is located inside the vault area (Dispenser location) of the cabinet.
To gain access and connect the power cord included in the accessory box, you may have to remove
the dispenser. Refer to your applicable Installation or Service manual for removal procedures of
your dispenser.
1. Obtain the power cord that is located in the accessory box. From the exterior of cabinet, feed the small end
of the cable through the closest cable access hole (lower part of cabinet).
2. Connect and route the power cord in the unit as shown in figures below.
TDN 07100-00084 Rev C
3. Reinstall the dispenser, if applicable.
FT5000
XP
RL2000
FT7000
  • Page 1 1

Triton Systems FT7000XP Series Owner's manual

Brand
Triton Systems
Model
FT7000XP Series
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents