DK Digital DWS-100 Owner's manual

Type
Owner's manual

DK Digital DWS-100 is a weather station that measures temperature inside and outside. The device requires two “AG 13” batteries and can display time in both 12 and 24-hour formats. To set the time, use the HOUR and MIN buttons. To toggle between Fahrenheit and Celsius, use the °C/°F button. To view the maximum or minimum temperature measured, press the MIN/MAX button. The device can also display a frost symbol when the outside temperature reaches between +4 and –1 °C. To reset the device, press the button behind the RESET opening on the back side.

DK Digital DWS-100 is a weather station that measures temperature inside and outside. The device requires two “AG 13” batteries and can display time in both 12 and 24-hour formats. To set the time, use the HOUR and MIN buttons. To toggle between Fahrenheit and Celsius, use the °C/°F button. To view the maximum or minimum temperature measured, press the MIN/MAX button. The device can also display a frost symbol when the outside temperature reaches between +4 and –1 °C. To reset the device, press the button behind the RESET opening on the back side.

3
Inserting batteries
The weatherstation needs 2 x “AG 13” batteries.
Ø
Open the battery compartment. Unscrew the screw fixing
the battery compartment cover using a small screw driver
for recessed-head screws.
Ø
Remove the battery compartment cover and take out the
batteries (if necessary).
Ø
Insert two unused batteries (type “AG 13”) so that their
+ poles faces the outside. When doing so, you have to
comply exactly with the correct polarity, otherwise the
weather station will not function and may get damaged.
Ø To ensure a longer and more useful economic life, you
should use Alkaline batteries.
Ø
Close the respective battery compartment.
Ø
Batteries must not be disposed of in domestic
waste. Please hand in used batteries at the proper
collection point or at the place where you have
bought the new ones. Never throw batteries into
fire.
2
Setting the time
Ø
Press the HOUR key repeatedly until the desired number
of hours is displayed.
Ø
Press the MIN key repeatedly until the desired number of
minutes is displayed.
Ø
To change the time display format from 12-hour to 24-
hour format push the 12/24 key for one second. When the
desired format flashes for 2 seconds, it is set.
Temperature measurement
Ø
If you would like to also measure the outside
temperature, place the device near a window.
Ø
Peel off the foil of the outside sensor and stick it to a
suitable smooth surface outside, possibly on the outside
of the window.
Ø
If you press the MIN/MAX button once, the display will
show for 5 seconds the maximum temperature measured
so far.
Ø
If you press the MIN/MAX button twice, the display will
show for 5 seconds the minimum temperature measured
so far.
3
Ø
If you press the CLEAR button during these 5 seconds, the
value will be deleted.
Ø
The symbol on the right of the temperature shows the
temperature trend:
: temperature rise by more than 1 °/hour,
: temperature fall by more than 1 °/hour,
: constant temperature.
In order to set back the trend measurements, press the
CLEAR button during normal display.
Ø
In order to switch the unit of the temperature display
between Fahrenheit and Celsius, shortly press the °C / °F
buttons.
Ø
If the outside temperature should reach a value between
+4 and –1 °C, a snowflake will appear on the display as a
frost symbol.
Reset device
Ø
If the device functions seem to be faulty or if you would
like to reset all settings, press carefully with a sharp
object on the button behind the RESET opening on the
back side of the device.
4
Waste disposal
When the operating life of this device has en
-
ded it must not be disposed as domestic was
-
te, but in accordance with national
environmental guidelines.
5
6
7
© 2005 Copyright
We reserve the right to correct errors and make technical
alterations. This manual is copyrighted. All rights reserved.
Neither the manual as a whole nor excerpts may be
reproduced without our prior written permission.
DK digital AG, 40878 Ratingen, Germany
www.dk-digital.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

DK Digital DWS-100 Owner's manual

Type
Owner's manual

DK Digital DWS-100 is a weather station that measures temperature inside and outside. The device requires two “AG 13” batteries and can display time in both 12 and 24-hour formats. To set the time, use the HOUR and MIN buttons. To toggle between Fahrenheit and Celsius, use the °C/°F button. To view the maximum or minimum temperature measured, press the MIN/MAX button. The device can also display a frost symbol when the outside temperature reaches between +4 and –1 °C. To reset the device, press the button behind the RESET opening on the back side.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI