Astonica 40208212 User manual

Brand: Astonica

Model: 40208212

Type: User manual

Read the instructions and precautions before use of this product

Please keep this instruction manual for future reference

Model No: 40208212

Classical Fountain

Instruction Manual

310809rev1

For warranty information, please refer to the back page of

this instruction manual.

Made in China

Distributed by:

World Factory, Inc.

Westlake, TX 76262

Due to ongoing product development

the actual product or products may vary from

the illustrations or photos shown within this manual.

NOTE: This product is intended for residential, non-commercial use.

For Manuals, Replacement Parts or Customer Service visit:

www.ezreplacement.com

Limited Warranty

World Factory, Inc. Products for Home Use

World Factory, Inc. (Seller) warrants to the original Buyer only, that each Astonica Product will be free

from defects in material and workmanship for a period of one (1) year from date of purchase.

SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED

WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH

ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE SELLER

WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY FROM

REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER

MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This

warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to

normal use or weathering. To make a claim under this Limited Warranty, you must return the complete

product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service

center. Call 1-888-422-7800 or visit: ezreplacement.com for the location of the nearest authorized

service center.

Additional Limitations

THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED

TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)

YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL

OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF

PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.

If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such

provision shall not affect any other provision herein, this Limited Warranty shall be construed as if

such invalid and/or unenforceable provision had never been contained herein.

This warranty gives you special legal rights, and you may also have other rights which vary from state

to state.

This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all

prior agreements, arrangements, or understandings between the parties relating to product warranty.

ASSEMBLY INSTRUCTIONS

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

PARTS & HARDWARE LIST

PART # DESCRIPTION QUANTITY

A Large Basin 1

B Medium Basin 1

C Small Basin 1

D Post 1

E Pedestal 1

F Base 1

G Fountain Cap 1

H First Tier 1

I Second Tier 1

J Rubber Stopper 1

K Pump Assembly 1

L Screws 3

CAUTION: Do not over tighten fasteners.

2. (SEE FIGURE 2) Pass Pump Assembly

Power Cord (K) through the hole in the

Large Basin (A). Pull through until the

Rubber Stopper (J) ﬁxed to the Pump

Assembly Power Cord can be pushed into

the hole to form a water-tight seal.

3. Assemble Pedestal and Post (D) to Base, (F)

passing Pump Assembly Power Cord

through each item as required.

1. (SEE FIGURE 1) Secure Pump Assembly (K) to

Large Basin (A) using the three screws (L).

4. (SEE FIGURE 3) Push the cascade tiers and

Medium and Small Basins onto the metal

pump spout. Screw the Fountain Cap (G)

onto pump Spout.

5. Place bath on a level surface and ﬁll with

clean fresh water.

6. Connect the Pump Assembly Power Cord to

the nearest indoor AC Power Outlet.

7. Care: The bath will require a minimum of

1-gallon of water to function correctly.

Clean the pump with a soft bristled brush

and clean water. Flush through using a

garden hose. The ﬂow rate of the pump can

be adjusted using the small lever at its

base. During hot weather the water can

evaporate quickly causing the pump to run

"dry" resulting in possible damage/failure

to the unit. Keep the large fountain basin

full and do not leave it running unattended.

If you notice the pump's performance

deteriorating, check for blockages and or

clean the pump.

The fountain should be placed on level

ground. Clean the pump and bath regularly.

Do not allow water to become overgrown

with algae. Do not place aquatic plants in

the fountain. Do not place pump in any

liquid other than clean water. Do not use in

water above 86 degrees Fahrenheit. Do not

lift, pull or carry the pump by the power

cord. Do not plug the transformer into an

outside socket. Do not run the pump "dry".

Figure 3

Figure 2

Parts Detail List

Pump Assembly

Power cord

Figure 1

Metal Spout

Astonica 40208212 User manual

Astonica 40208212 User manual

Astonica 40208212 User manual

Related papers

Other documents