QUICK START GUIDE
SC541
1
Table of Contents
1.Packing List............................................................................................................................................ 2
2.Hardware Introduction ........................................................................................................................2
3.Installation............................................................................................................................................. 3
4.Access from Web Browser ................................................................................................................ 3
2
1.Packing List
2.Hardware Introduction
3
Installation Notes
Before installing the device, please make sure the device has two AA batteries installed or
use Type-C power supply.
Need to use bracket or other way to fix the device, there are bracket holes on the back and
bottom of the device.
To avoid reflections from the meter surface, make sure the device is angled to the meter, not
directly in front of it.
The best distance between the device and the target to be captured is 15~25cm, you can
also log in to the webpage to view the live image stream for adjustment.
SC541 device provides user-friendly web GUI for configuration and users can access it via Wi-Fi.
The default IP address: 192.168.1.1
Step1:
Press the external button once to wake up the device.
Step2:
Connect the device to WiFi,then type 192.168.1.1 to access the web GUI.
4.Access from Web Browser
3.Installation
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Note:
When there is no operation for 5 minutes, the device will enter sleep mode. To wake up the
device again, please press the external button again.
/