MULTIPLEX Nugget Ice Agitator Installation guide

Type
Installation guide
Part No. 020001381
Revision 0
Instructions Nugget Ice Agitator Installation
Agitator Removal
1. Disconnect or shut off power supply to
Ice Beverage Dispenser and Ice Maker.
Failure to do so may cause electrical
shock or injury.
2. Remove Ice from Beverage Dispenser
Bin.
3. To remove the agitator, unfasten the pin
from agitator. Pull pin out of agitator
and paddle wheel. (See figure 1)
4. Push agitator towards the back of the
unit, farther into the white agitator
bushing. (See figure 2-A)
5. Pull and move the agitator to the side,
removing the agitator from the white
bushing and the unit. (See Figure 2-B)
Figure 1
Figure 2-A Figure 2-B
Part No. 020001381
Revision 0
Instructions Nugget Ice Agitator Installation
MD Spiral Nugget Ice
Agitator Installation
1. Insert the end of the agitator into the
agitator bushing. Push the agitator into
the bushing far enough to allow the
agitator to pass the end of the paddle
wheel. (See Figure 3)
2. Insert agitator shaft into motor shaft,
align holes and insert retaining pin
(See Figure 4)
3. Insert split ring to hole on end of
retainer pin. (See Figure 5)
Note:
The Ice Level Management Kit (Part
Number 5028738) should be installed at
this time.
Figure 3
Figure 4
Figure 5
Kit Nugget Ice Management
020001382
Item Description Qty
020001380 AGIT W/ SPIRAL ASSY 1
020000567 AGIT W/ SPIRAL 1
020000595 PIN RETAINING 1/4 X 90 1
5028715 RING SS SPLIT 1
020001381 INSTR AGIT W/ SPIRAL 1
5028738 KIT ICE LEVEL MGMT 1
  • Page 1 1
  • Page 2 2

MULTIPLEX Nugget Ice Agitator Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI