Lightolier
45 INDUSTRIAL WAY, WILMINGTON, MA 01887
INSTALLATION INSTRUCTIONS FOR THE LYTECEL.-.EL LUMINAIRE
NOTE: Fixture should be installed by a qualified electrician
© Lightolier 2007 59-31160-000 Printed in U.S.A.
HANGER MOUNTING LOCATIONS
2
FEED END / CONTINUOUS END
1
46-5/16" (1202mm)
Feed End
4'
Unit
8'
Unit
4'
Unit
8'
Unit
Feed End
Continuous End
Wago Plug-in
Wirenuts
4
TO REMOVE LOUVER, follow arrows 1, 2 and 3. To
install Louver, reverse the procedure. For
continuous row mounting, remove End Cap as
shown. Use End Cap for end of row fixture.
3
Nut (4)
Washer (4)
Fixture
Threaded
Stud (2)
Wago Plug-in
Supplied
#14 Gauge
Maximum Wire
Solid or
Stranded
End Cap
Threaded
Stud
End Cap
Tab (2)
Louver
Fixture
Nut
End
Cap
FOR CONTINUOUS ROW MOUNTING, assemble
Fixtures using Threaded Studs (2), Washers (4),
and Nuts (4) from supply pack included. Make
plug-in wire connections.
1
2
3
94-9/16" (2402mm) Hanger location for individual unit
95-1/4" (2419mm) Beginning or end of row and hanger location
Washer
96-19/64" (2446mm)
Hanger location in
continuous row
Twist-on Wirenuts
Twist-on Wirenuts
Wago Plug-in
Wirenuts
Continuous End