RV Gas Pilot-Thermocouple
Assembly Instructions
TO INSTALL:
1. Attach pilot assembly to main burner with screw (Fig. A-5);
tighten securely. Pilot flame spreader should be
approximately 1/8" from end and side of main burner.
2. Install assembly onto combustion tube with screw (Fig. A-2);
tighten securely.
3. Secure thermocouple lead (Fig. A-3) to control. This is a flexible
tube and can be bent to fit. CAUTION: Do not bend this lead
within 1/2" of either end. Tighten finger-tight plus 1/4 turn
with wrench.
4. Firmly tighten pilot gas line to control.
5. Position air shutter and insert screw (Fig. A-1).
6. TURN ON GAS SUPPLY and turn control to pilot position
(push button if applicable).
7. NOTE: CHECK all connections for leaks using Camco Gas
Leak Detector (10322, 10323, 10324) or equivalent prior to
using equipment.
8. Adjust main burner per instructions.
Stock # 08783 RV Gas Pilot Assembly
Replaces Atwood #91603 and #91214
Stock # 08773 RV Gas Pilot Assembly
Replaces Atwood #92616 and #91603
RV GAS PILOT ASSEMBLIES
Stock # 08763 RV Gas Pilot Assembly
Replaces Mor Flo #690-0755 and #320-0069
Fig. A
Thermostat Control Valve
Pilot Assembly
A - 2
A - 5
A - 4
A - 1
A - 3
Fig. B
3/8"
5/8"
NOTE: Robertshaw pilot assembly #08773 gas tubing mounts on left
side of burner tube. Robertshaw pilot assembly #08783 gas tubing
mounts on right side of burner.
NOTE: If your burner does not have a mounting hole on right side, drill
a 3/16" hole, as shown below.
TO REMOVE:
1. SHUT OFF GAS SUPPLY and turn gas thermostat control valve to
OFF position.
2. Remove air shutter screw (Fig. A-1) and slide air shutter to right.
3. Remove main burner screw (Fig. A-2).
4. Unscrew thermocouple lead (Fig. A-3).
5. Unscrew pilot gas line (Fig. A-4).
6. Remove burner and pilot assembly from water heater. Pilot
assembly can now be separated from main burner by removing
screw (Fig. A-5).
z884015 #1008
Camco Manufacturing, Inc.
121 Landmark Drive / Greensboro, NC 27409
1-800-334-2004 / www.camco.net
/
