12V 2A
12V 2A
Computer
Phone
Power Cord
AC Power
Adapter
Ethernet
Cable
CPEi 300
Phone Line
*Optional
steps
L1 L2
L2L1
Connect the cables in
numerical order as shown.
Cable Connection Guide
1
2
*6
3
4
5
*7
No computer software applications or drivers are required to complete installation.
Connect the power cord and power adapter together.
Plug the power adapter into the power connector on the back of the unit.
Plug the power cord into an AC outlet. The unit will turn on.
Plug one end of the Ethernet cable into the Ethernet connector on the back of the unit.
Plug the other end of the Ethernet cable into the Ethernet connector of your computer.
Plug one end of the phone line into an activated phone line connector on the back of the
unit. Phone line activation is dependent upon your service contract.
Plug the other end of the phone line into the phone line connector of your telephone.
At your computer, open your browser and enter http://mywimax. (with a dot at the end)
into the address field and press the Enter key. A wizard will start up to guide you through
the installation.
Follow the directions in the wizard to complete the installation. When using the wizard
for the first time, use the default value provided by the wizard as the password.
Procedure to Install the Unit
5
*6
*7
8
9
4
3
2
1
PMS 297 C
100%
A4 (210mm x 297mm) folds to A6 (105mm x 148mm)