Intermec HN2MG18 User manual

Intermec
Brand
Intermec
Model
HN2MG18
Type
User manual

This manual is also suitable for

Exhibit O: User Guide 2
FCC ID: HN2MG18
Quick Start Guide
P/N 962-054-029
Revision B
March 2001
700 Series
Mobile Computer
*962054029*
P/N 962-054-029 Revision B
700 Series Quick Start Guide
-2
Packing List
Check to ensure that you receive these
items:
Compliance Statement
Product Warranty Card
700 Mobile Computer
700 Series Quick Start Guide
-3
End User License Agreement
End User Software License
700 Series Quick Start Guide
-4
Getting Started
The Main Components
Exterior Features
Front
Back
Battery
compartment
Speaker
Stylus
IrDA
Action key
Backlight
(Gold + 3)
Esc (Escape)
Gold
BkSp (Back Space)
ON/OFF
ENTER
Contrast
(Gold + 1 or 2)
Navigational
key
Scanning LED
Power Status
700 Series Quick Start Guide
-5
First Thing Before Using: Charge
the battery four hours.
Connecting to Charger
1
2
Booting Your
Computer
The following steps outline the initial
boot and Pocket PC load on your 700
Series Mobile Computer.
1. The bootloader which resides in
flash, loads the operating system
from the CompactFlash card into
RAM.
2. The first time your computer is
started you may have to cali-
brate your display screen. You
need to calibrate the screen if it
is too inaccurate to use the touch
screen. Run through the tutorial,
set your time zone region, and
follow the prompts.
700 Series Quick Start Guide
-6
3. The AutoRun feature of Pocket
PC searches for the AutoRun.exe
in the \2577 folder on the Com-
pactFlash card. If found, the pro-
gram executes.
If no applications are auto
started then the “Today” screen
appears.
Pen Calibration Utility
1. Press [Gold] and [0] to open the
Start menu.
2. Use the navigational key to scroll
down to settings and press
[Enter]. You need to get to the
System tab.
3. Press the down and/or right and
left arrows (not tabs) until one of
the items on the screen is high-
lighted.
4. Press the right tab until no items
are highlighted.
5. Press the right arrow
[Gold][right arrow] to bring up
the System tab.
6. Press the up or down arrow until
“Align Screen” highlights.
7. Press the [Enter] key once then
again to start the align process..
8. Recalibrate the screen by touch-
ing all the targets at the center
of the cross hairs.
9. Verify the calibration settings
were saved and is now on target.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Intermec HN2MG18 User manual

Intermec
Brand
Intermec
Model
HN2MG18
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents