VISUAL COMFORT CHC4163 User manual

Brand: VISUAL COMFORT

Model: CHC4163

Type: User manual

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (B) from canopy (D) by unscrewing.

3. Wrap fixture ground wire (bare copper) around the green grounding

screw (see diagram 1). Tighten. Continue fixture ground wire and

connect to supply ground wire (usually green or bare copper) using

wire nut (A).

NOTE: It is imperative that the fixture is grounded.

4. Connect fixture neutral wire (white) to the supply neutral wire (usually

white) using wire nut (A).

5. Connect fixture hot wire (black) to the supply hot wire (usually black)

using wire nut (A).

CAUTION: Do not reverse the hot and neutral connections.

6. Make sure all wire connections are tight, then carefully tuck into the

junction box.

7. Install mounting plate (B) to junction box and secure with mounting

screws (C).

8. Thread canopy (D) to mounting plate (B).

9. Thread fixture frame to canopy (D).

NOTE: Do not overtighten otherwise fixture frame could become

damaged.

10. Install light bulb into the socket.

11. Install bottom frame (N) to fixture frame and secure with screws (O).

Cynara Large Flush Mount

Item # CHC4163

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

Phillips Screwdriver Slotted Screwdriver

NOTICE:

G (10PCS)

Diagram 1

Bulb not included

F (10PCS)

J (10PCS)

H (10PCS)

E (10PCS)

K (10PCS)

I (10PCS)

M (10PCS)

L (10PCS)

LED

Diagram 2

Cynara Large Flush Mount

Item # CHC4163

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

12. Install decorative part (E through M) by securing to fixture frame as

shown in diagram 2.

Note: : Start from bottom (layer 1) and work your to the top (layer 9).

Care Instructions: Clean only with a soft dry cloth or feather duster. Do

Not use abrasive or chemical agents.

NOTICE:

LED

Layer 9

Layer 8

Layer 7

Layer 6

Layer 5

Layer 4

Layer 3

Layer 2

Layer 1

G (10PCS)F (10PCS) H (10PCS)E (10PCS)

2.75"

5.5"

3.25"

4.25

3.25

3.75"

I (10PCS)

3.5"

K (10PCS)

3.5"

2.75"

L (10PCS)

3.25"

1.75"

J (10PCS)

3.5"

3.25"

M (10PCS)

VISUAL COMFORT CHC4163 User manual

VISUAL COMFORT CHC4163 User manual

VISUAL COMFORT CHC4163 User manual

Related papers

Other documents