2. Pia Ricco
  3. 1JAY-50334BZ
1JAY-50334BZ

Pia Ricco 1JAY-50334BZ User manual

  • Hello! I am an AI chatbot trained to assist you with the Pia Ricco 1JAY-50334BZ User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TOOLS REQUIRED
CAUTION
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
• Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect in
the wire, do not attempt installation.
• Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Fixture
Fixture
Mounting Unit
Mounting Unit
Mounting
Mounting
Screws
Screws Wire Nuts
Wire Nuts
Chain
Chain
Canopy
Canopy
Screw Collar
Ring
Screw Collar
Ring
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
Assembly Instructions
STEP 1
Attach the iron rack onto fixture using ball nuts.
HARDWARE INCLUDED
INSTALLATION
Iron Rack
Iron Rack
Ball Nuts
Ball Nuts STEP 2
Attach the end of the chain to the loop
on the fixture.
STEP 3
Use the mounting screws to attach
the mounting unit to the junction box.
Bulbs
(not included)
EXPLODED PARTS
STEP 4
Pass the chain and the branchwires through the
screw collar ring and canopy. Feed the branchwires
through the pipe nipple on the mounting unit and
attach the end of the chain to the mounting unit.
STEP 5
Make the electrical connection from the junction
box to the fixture. Connect the ground wire to the
mounting unit using the preinstalled green ground
screw. Then, connect the positive, negative and
ground wires with the supplied wire nuts. Secure
with electrical tape
STEP 6
Secure the canopy to the mounting unit with the screw collar ring.
STEP 7
Install bulbs (not included)
Assembly Instructions
INSTALLATION
Smooth side of wire from
the fixture identified
with the label "L"
Ground wire from
the Fixture
Ribbed side of wire from
the fixture identified
with the label "N"
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
/