Server 100745 Owner's manual

Brand: Server

Model: 100745

Type: Owner's manual

Squeeze pinch valve open

to ensure it isn’t stuck

shut, then insert into

pump housing.

Press dome into housing fully and wrap loop

around lower opening to secure.

Install tube by lubricating

with a small amount of water

and rotate and position until

both pegs on housing t into

holes on tube.

Lubricate connector with

small amount of water and

rotate and position until

both pegs on connector t

into holes on tube.

Insert pump connector into

pouch tment and rotate locking

collar clockwise to secure. Prime

pump by pushing condiment

toward connector and squeeze

pump dome several times until

product is visible in pump.

Fold two back

corners of pouch

over side walls

and close lid.

This helps with

evacuation.

Place pouch in

rear compartment

of unit. Slide

pouch connector

grooves into unit

divider channel.

Insert pump into

slots inside front

of unit.

Place condiment

pouch on at surface

with pouch tment

facing upward.

Remove pouch cap.

Remove unit from

box and wash all

parts properly before

use.

Server Extreme™ Countertop Dispenser

Tips and tricks to help you get started with your new Extreme™ Dispenser.

QUICK START GUIDE

100745RevA

WANT TO LEARN MORE?

Visit server-products.com/manual-more for your

manual, part breakdown, support videos and more.

[email protected] | 800.558.8722

MODEL

XXXX

P/N

#####

SERIES

##X ##X

REFERENCE YOUR PART NUMBER

(P/N) LOCATED ON THE LID OR BASE.

Insert discharge tting into pump

housing discharge tube. Place loop

of tting around peg on end of

discharge tube to secure.

If you didn’t prime in step

8, press the lever several

times until you see product in

discharge tube.

Server 100745 Owner's manual

Server 100745 Owner's manual

Server 100745 Owner's manual

Related papers

Other documents