2. Teraflex
  3. 1743022

Teraflex 1743022 Installation guide

  • Hello! I've reviewed the installation guide for the Teraflex Adjustable Front Track Bar, part number 001743022(TBAF). This guide details how to install the track bar on XJ, ZJ, and TJ vehicles, including torque specifications and adjustment instructions for different lift heights. I'm ready to answer your questions about the installation process or the features of this product.
  • What type of vehicles does this track bar fit?
    Should installation be done with the vehicle on the ground?
    What is the torque specification for the lower end bolt?
Installation Guide for the
Adjustable Front Track Bar
Part #001743022(TBAF)
1. Remove the stock track bar.
2. Connect the upper end of the
track bar with the bolt. Be sure
to replace the cotter pin on the
pivot end of the track bar.
3. Adjust track bar to center the
axle under the vehicle. Use the
threaded center section and a
wrench to lengthen or shorten
the track bar.
4. Attach the lower end of the
control arm to existing hole
with the new bolt supplied with
the kit. Torque this bolt to 74
ft. lbs.
5. Once the proper length has
been determined for the track
bar, tighten the clamps on the
adjustable section so that they
clear other suspension compo-
nents.
Adjustment lengths from stock:
3” inch lift lengthen track bar 9/16”
4” inch lift lengthen track bar 3/4”
Revised 06 June 05
This front track bar will t all XJ, ZJ, and TJ applications.
Installation should be done with the vehicle on the ground.
Tera Manufacturing, Inc.
5251 South Commerce Dr.
Murray, Utah 84107
Phone/801.288.2585
Fax/801.713.2313
www.teraex.biz
INSTALLATION GUIDE
/