DV8 OFFROAD D-JP-180008-BL Installation guide

Brand
DV8 OFFROAD
Model
D-JP-180008-BL
Type
Installation guide
2007-09 JEEP JK MANUAL SHIFTER BEZEL
FOR PART #: JP-180008-BL
INSTALLATION INSTRUCTIONS PAGE 1 OF 1
www.DrakeOffRoad.com
INSTALLATION
1. Remove shifter knob by turning
back and forth to loosen wedge and
pulling fi rmly up at the same time.
See fi gure 1
2. Remove factory shifter bezel and
boot assembly by prying up on
the rear of the plastic bezel and
pulling up to release the two clips
retaining it to the console.
See fi gure 2
3.
MAKE SURE TO WEAR SAFETY GLASSES!
Turn assembly over and use a fl at
head screw driver to pry the two
plastic parts apart.
See fi gure 3
In most cases all the plastic weld
nubs will break off, but you may
have to go back and poke them or
drill them out.
See fi gure 4
4. Re-assemble using the lower
retaining ring, the boot, and the billet
bezel using the hardware provided.
See fi gures 5, 6, and 7
5. Reinstall assembly by hooking in
rear tabs fi rst and pushing down rear
until retaining tabs seat. Reinstall
shifter knob by lining up graphic and
pounding down into place.
See fi gure 8
TOOLS YOU’LL NEED FOR
INSTALLATION
• Flat head screw driver
• Flat trim removal tool
• 4mm Hex Key
• 8mm wrench
• Safety Glasses
130 Cassia Way • Henderson, NV 89014 • 702.853.2060 • 702.853.2062 Fax
IS.JP-180008-BL
JP-180008-BL
Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4
Figure 4
Figure 5
Figure 5
Figure 6
Figure 6
Figure 7
Figure 7
Figure 8
Figure 8
Thank you for your purchase of the
Drake Off Road Manual Shifter Bezel
for your Jeep Wrangler JK!
  • Page 1 1

DV8 OFFROAD D-JP-180008-BL Installation guide

Brand
DV8 OFFROAD
Model
D-JP-180008-BL
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents